Routing

Hi,i am trying to Establish IPSec VPN Tunnel between to ASA 5505. I assigned the IP address, enabled NAT, Configured the IPsec and IKE and other basic configuration. When i tried to Ping the inside address of the other end from inside network of this...

since I reconfiguring frame realy switch .. R1 can ping r2 and r3R2 can ping r1r3 can ping r1r2 can not ping r3r3 can not ping r2frame-switch#sho frame-relay routeInput Intf Input Dlci Output Intf Output Dlci StatusSerial1/1 1...

hi,Most of the times we are struck in the problem that we are not able to ping the device but in this weird case I am getting ping responce which is not expected. In our network of L2 switches and only one L3 switch which acts as default gateway for ...

hello,Is it possible to bridge the same subnet across a VPN.(i need to connect two audio devices that need to be in the same subnet)(it doesen't have to be secure.(no ipsec) it can be a gre tunnel))thank you,laszlo

Hi NetproNeed comparision between DMVPN Vs GRE IPSEC. Looking for Real Life pros&cons between them?

hi guysi have a strange issue when i confugre to bgp hops like bellow lo0--R1--OSPF--R2--OSPF--R3--lo0R1-----------EBGP--------R3i used the command ttl-security hops 3 on both sidesthe bgp session is and establishedthe loopbacks advertised in bgp ape...

Dear sir,Ihave cisco 2960 l2 switch in that out of 24 port iwant to use two ports are HUB ports .Is it possible.plz give me config examplesrini

Network is connected both AS 100 and AS 200.When the traffic arrive AS 6500 router, we would like to load balancing theTraffic both AS 100, and as 200, (remark : it's different AS)I searched the solution, and I found the 'bgp multipath'bgp multipath...

Dear All,now i would like to implement VPN from HQ to many branch. at HQ i have Cisco router 2821 and branches i have router 1841. the connection from HQ to branch i used fiber optic. after i configure VPN from HQ to branch, the connection from HQ to...

hi,I was reading CCIE R&S by Wendoll Odom about BGP Nexthop, see the diagram. It first gives a problem in this scenario, "R4's route to 30.0.0.0/8 through R2 lists R1 IP(1.1.1.1)....Unfortunately, R4 doesn't have a route for 1.1.1.1 on R1, so that ro...

6509 switch's alert light is on.Could you pls give me a guide where to look exactly.thx

Hi All,My question is where would i place my wireless controller within my LAN.I've been advised to place one within my network to better manage APs' How our office is configured.6 Large Floors, On each floor 4 APs> 2960 Switch > 3750 Switch [ Two of...