Routing

We have a remote site that has a primary WAN link via a DS1 and a 512kb backup link via satty. Routing is via eigrp and the DS1 is the primary link, however we have been experiencing a lot of errors on the link that impair service. The errors are n...

Slot # Card Specifc Leds 17 MBUS-OK18 MBUS-OK19 MBUS-OK20 MBUS-OK24 MBUS-OK MAJOR-ALM MINOR-ALM25 MBUS-OK MAJOR-ALM MINOR-ALM28 BLOWER-OK SLOT 24 ...

In Australia here, the big Telco has just allowed home users to have 8M adsl connections. I've taken up a 8M/384K ADSL plan and can not get sync using my Cisco 827. I've tested with various modems already like the Netcomm NB5, Netcomm NB4, Netcomm 13...

I have a 2811 router with a connection to a cisco switch. I recently unplugged the MPLS connection to a backup VPN connection for maintence purposes. After my maintence, I removed the VPN backup connection and put the MPLS connection back into the r...

Hi All,I have to following question: Can CEF operate together with Policy Based Routing on a vlan interface? The switch is a 6509 with IOS Version 12.1(26)E, RELEASE SOFTWARE (fc1).Thank in advance for your reply.Kind regards,Hary

i do have this quistion whish produkt line can I go to now I have 8510 with only 4 ports oc3stm1 mm and 4 port oc3stm1 sm but the 8510 is end og life best regards Peter

i have to connections on router 2600 i configured eigrp to load balance, they worked well for some times then after a while i found that load balancing is not working even though CEF is enabled on both interfaces.and i put this command ip load sha...

A general question for best solution on redundecy.I have a site that needs redundency with HQ. (See attached file.)Have two connections, providers net and internet vpn.Previous we used a leased line with our own router, the VPN router and HSRP betwe...

hi all,i ve an 1841 router with wic-1T which is holding one public ip,and fast ethernet0/0 also having public ip and its connecting to ASA box.now i want to connect a device say 10.10.10.5/24 to outside world to access internet, and i ve one public i...

Hi all,I have read that on catalyst 3560/3750 it isn't possible to configure tunnel gre.If so, which is the minimum platform, among catalyst, that supports tunnel gre? 6500/7600?RegardsGianluca

can anybody tell me what is the difference between 1841 Secutiry Bundle, Adv.Security, 64FL/256DRl-1-Port Serial WAN Interface Cardand1841 Modular Router W/2XFE,2WAN Slots,32FL/128DR.and which one is better?

Here is the scenario . R2 and R6 are in the same AS 1 . Backbone 2 in the AS254.AS254 -------- R2 -------R6---------AS 254Configure R2 such that only AS paths originating from AS 258 are permitted from backbone 2.Use a filter for this task.? Configur...

Can anybody confirm my thoughts? 12.4(11)XJ supports ADSL2+ and it can be installed on a Cisco 831.But it won't make the 831 router able to handle ADSL2+ ?!Am I right? I understand, that only routers above 850 support ADSL2+.Mike