Routing

Hi all,I come across a case that I have two Video conferencing end-device interconnecting with routers and Internet.One end router needs to configure NAT for VC and the other end of VC binds real IP address.I find that private-IP VC can send video bu...

Hi All,Quick question regarding bridging on VWIC-1MFT-G703 cardsBrief scenario:site A:G.703 cct--->2801<---G.703 cct:site BCircuits on each site will connect to routers that will provide IP addressing. 2801 in the middle terminating both G.703 circu...

Could this be related to Software defect CSCsd37629 ?Would removing the inspect statements on the interfaces only or the global inspect statements help ?ORWould upgrading to c7200-advipservicesk9-mz.124-9.T1.bin help ?

Hi, we have 2 different Internet Service Providers, what if i plan to have both the ISP's on a single router with 2 WIC's? how good is that? because a default route will be pointing towards the internet like "ip route 0.0.0.0 0.0.0.0 serial 0". in...

i have a 2621xm router that has a nm-hdv2 net mod with a 2 port vwic 2mft t1, slot 1 also has a two port 2mft t1, slot 0 has a wic 1dsu t1 - can i replace the wic 1dsu t1 with a vwic 2mft t1 card to allow for one more t1?my question is can you have a...

Take a look at both pictures. Does it make sense to change from one to the other, regarding speed, redundancy, etc?If the 2 switches are (Cisco Stack-wise technology) stacked, would it really make a difference on performance versus the seperate pictu...

Hi there,My customer has a 2950T-24 using WS-G5486 GBICs in one building and in the other he uses WS-2060s with GLC-LH SFPs. Fiber runs between the 2 buildings. What sort of media converter do I need on each end to connect the switches? Please advise...

I Am relatively new to Cisco stuff, but want to learn and think Cisco-way by working with the equipment.I've got a 4402 WLAN controller with LWAPP's, several switches already configured and up-and-running.The equipment will be installed on a mobile e...

Hi all,Can someone please help us with a problem we are having setting up a couple of Cisco 1700 Routers? We are currently trying to set these routers up to link two sites together, one is sitting in our main office (IP 10.54.1.252/255.255.0.0) and t...

It seems that WPA2 is not supported on ISR routers, only true Access Points:http://www.ciscotaccc.com/wireless/showcase?case=K68400254 Anyone know if/when WPA2 will be supported? Is this just an IOS software issue, or will it require a hardware upgr...

Hi ,I have two different output commands for the same interface atm5/1/0 ?Every body know why ?Router #sh int atm5/1/0Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 149357 Output queue :0/140 (size/max)Router#sh controllers vip 5...