Routing

Dear All,Can i get any document on WS-X6608-E1 module .?regds,aman

Good morning! Is it possible to connect an ATM "back to back" link between 2 OC3 interfaces? (NM-1A-OC3MM One-port ATM OC-3 Multimode NM) Wich is the configuration? Thanks for your advices.

I have an Internet router running eBGP with my ISP. My Internet router is receiving a default route learned from the ISP. My Internet router is is then redistributinging itself as the defualt route to my internal router/network via iBGP. This works f...

Hi All,I have a Cisco 10008 currently have been configure to terminate L2TP (as LNS) and PPPoE session and work perfectly.What I like to do now is to configure SSG to provides service to IP connected users downstream.Can I run LNS, PPPoE and SSG func...

HiDoes anyone know a good command to determine the clock speed on a serial circuit?Show controllers sometimes gives it, but on some routers it doesn't....ThanksAaron

Hello there,I'm just wondering if anybody had advice on which router would suit the following scenario:The router will sit in a remote location connected to a public X25 switched network. Into the router will arrive approximately 100k make/break X25...

One of our AS5350 gateways suddenly stopped working. Config was not changed for months, and everything was working fine. But yesterday VoIP calls originated by our Softswitch that are supposed to be terminated trough that GW started failing. At that ...

While redistributing ospf into bgp , I encountered the following behaviour :Consider the existing config like:router bgp 100redistribute ospf match internal metric 77Then I configured as below :router bgp 100redistribute ospf match external metric ...

We recently purchased a router 1721 with IOS 12.3(7)T1. It was purchased through a vendor who supplies our IT equipment. I am finding it difficult to get the Cisco TAC support. Though I am Cisco customer, I am not able to open the service request. Th...

We are trying to do something that I am not sure is possible.Using a loopback interface with .97 as the inside source interface for outbound traffic. That works fine. Also if we put up a static mapping 10.1.1.2 to .98 that works and the traffic is ...

The network consists of dual 6500 series catalysts servicing as core switches/routers. Attached to the core are two 3700 catalysts operating as access layer devices with both layer-2 and layer-3 interfaces, and a single 7600 series router as the netw...

I am looking for a modem to purchase to use for dial backup with the 871 router. i have looked online but can find no modem model that i could use for this. any help would be appreciated. below is an excert i got from the 871 product pageConsole-au...

We have a 1605 that we are trying the following: Our ISP is providing a DSL circuit with a single public IP address 69.xx.xx.130. We would like to assign that address to ethernet1 and then configure ethernet0 with an internal ip address 10.0.0.1. The...

Hi there,1.Can someone please tell me what products do I need for the new CCNP labs (MSCI, MCMSN, ISCW and ONT). We are CNAP.2. Is it possible to upgrade our 2600xm series routers to support the new CCNP labs? Where can I obtain the CNAP price inform...

We are starting to look at putting video over our AT&T MPLS Cloud. We have a 4.6 meg port with a 2.28meg cir. Our COS from AT&T is Ingress 60/40/0/0 and Egress 60/67/22/11. Attached is our current QOS Setting. There are only two classes set up now; V...