Routing

I have a lab environment and I need to somehow lower/delay t1 link interfaces. I am looking to make the links be about 128K or so. I am using wic-1dsu-t1 cards in all routers with cross over t1 cables. Can someone let me know of the command or comman...

Please bear with me as I have only been administrating cisco devices for about 2 months.I got handed this project when our net admin was fired.My company has two datacenters. At our new datacenet (DC-A) we have a cisco 3845 and at our old datacenter ...

All, we have a DS3 Frame circuit of 30 Meg port with a 6 meg cir. I am planning to use a 2811 with a NM-1T3 card,I need some help in confirming the configuration of the controller card.I am thinking i wont have to change anything in under the control...

Can u help me how to configure isdn with router console port.I will be grateful if u help me out...Sandipan Dutta

Hi,I want to implement multihoming on my 7206 VXR. i have checked different scanrios on Cisco sit they heled me e.g,http://www.cisco.com/warp/public/459/27.htmli want more infomation and more scancrios on mulithoming. waiting or ur reply.Thanks

Hi All,I have Vlan with IP address assigned and "no shut " command issued. But no ports are assigned to the Vlan. In this case Vlan will be up or not ? ( As the Vlan is Logical Interface i guess it should up/up )Rajiv

Can there be more than one DR and BDR in a single OSPF area (multi access network)? If yes .Is it posiible that there may be different DR and BDR for different subnets in one single OSPF area? Please explain..

What would be the required hardware to split a T1 connect in between two 7200 routers? I want to implement two routers in a active/standby role using hsrp on one side of T1, in case one router dies i want the standby to come and use the same T1 line ...

Hi All:I have 1 quick question. We have a 3 T1 bundle and our monitor has spit out a graph that showed over 6 MB consumption for a brief period of time.Drilling down I see bandwidth in and out were added to compile this.My question - is a T1 bandwidt...

Currently I am working on a project involving a Hospital in Conneticut which has four wan connections which are a combination of ATM, T1, and 56K. I need to come up with a new design which will carry the hospital into the future with voice, video, l...

We are in the process of implementing a vendor supplied MPLS WAN which uses BGP between the CE and PE routers. We are using EIGRP on the current Frame-Rely LAN\WANi cannot get BGP route into EIGRP in router CegRouter Arouter eigrp 123 redistribute bg...

Hi All,I have a problem in a leased line, but while troubleshooting with the teleco if found out that when the make a HW loop i notice that my serial interface showing the following:Serial13/1/7:0 is up, line protocol is down (looped) while using PPP...

I have two WAN links (fiber) of 100Mbps with one customer, in my company we have two Cisco 3845 routers and in the customer there are two Cisco 2691 routers. When we enable OSPF between the routers the adjacency isn´t established and in the router...

We have two 6509's, one running Hybrid and the other running Native IOS. Our end goal is to consolidate to one 6509. My question is, what version of CatOS is needed to support this and what are the recommend steps to move the 2 CSM'S and 2 SSL modul...

Dear sir, Anyone know how to trace windows login username from client host?Please advise. thanks.