Routing

hishould I enable portfast on the firewall port from the catalyst ?I have Cisco Catalyst WS-C3550-12Tgreetingspiotr

Our MPLS carrier does not pass EIGRP traffic but does allow OSPF.I am going to convert from EIGRP to OSPF on 10 Routers,I need to know what steps should I take for design and are there any documentation that details this procedureThanks

I just want to know if once you set an interface as SPAN Destination (Monitoring) Interface, you can not access (eg ping) any device attaches to that interface. Is this the case or something wrong with my switch? I need to ssh the computer attached t...

hiknows someone why I have on port 8 on the catalyst WS-C3550-12T switchport trunk pruning vlan 2--------------------------------------------------------------# sh run.......................interface Port-channel1 switchport trunk encapsulation dot1q...

Does anyone have a link to some some documentation on the relationship between bandwidth and throughput? Maybe on how to calculate (formula) how much throughput you can get for a given bandwidth.Also I can remember reading a cisco document a few year...

hihowto enable RSTP on ports 10 & 11 on the Catalyst WS-C3550-12T ?kind regardspiotr

We have a remote and host site connected via a frame relay cloud. The remote site is a new location and is running a newly purchased 1721 router. The site runs good until a moderate load is placed on the circuit then it slows down significantly. This...

Hi all:I had posted a bit earlier about some frame errors that I was seeing on my 7204 router. Whenever a machine tries to download a file from a remote site, I get a lot of the following errors:TCP Previous Segment LostTCP Dup AckTCP Retransmission...

Dear Pro,I buy new brand 4 port FE Card (WIC-4ESW)and instaled it on my router, after i check with show interface, there's no new interface, FYI my router running IOS 1700 ver. 12.2(13)T4, what should i do?.thankyou Haris

Hi we have a circuit in HK just installed by PCCW.They PCCW say its a T1 1536k link Unframed/B8ZS with a G.703/RJ45 interface.Firstly we have a VWIC2-1MFT-G703 card will this work? On the card itself under the rj45 port it sal CTRLR E1 0 The part num...

I am currently try to configure a 837 with a block of 16 public ip address i do not need private ip's dhcp dns or anything else from the router just for the usable ip to be routed back and fourth can any one point me in the right direct for some conf...

I have customer with multiple sites connected via MPLS WAN.The same sites were linked with ( same bandwidth) the second MPLS service provider for link redundancy and load sharing.Customer is running ospf.Sooner when we connect a SINGLE location to th...

Is is possible to restart a single process (e.g. ospf) other than reload the router?

We have a WAN that consists of 4 locations. Site A has 2 T1 connections to the Internet and there is a 3825 router running BGP to handle the connections. Behind it are 2 PIX 515e's in failover mode. Site B has a connection to Site A using SBC's G...