Routing

HiI am trying to configure the Cisco 7603 as a IPv6 stateless DHCP server & 7204 as client. I am not sure what I am missing in the configuraton. Following are the configuration from 7603:interface GigabitEthernet3/1 no ip address ipv6 address FE80::1...

We have a single router on our LAN that is for third party connections. I want to run OSPF for these connections so that the routing is dynamic. However I want to stop each 3rd party receing eachothers networks - what options do I have??

Hi All. I'm a budding CCNA (i.e. not as experienced as I'd like!). We had the above supervisor fail last night, we've put in a new supervisor - but neithert my boss or myself has had to do this before. The hardware side of it is done, the old flash...

Hello Guys, Please find the attached file to understand the scenario and problem.Regards,MAX

HelloI have installed v.35 card (PA-8T-V35) with octal cable. The problem is this that i cannot see 'show controller' information for serial ports. 'show contrller' support only this:Router#show controllers ? E1 E1 controller internal state T...

Do you know if there are any ready-to-use network documentation forms to download?

Hello GuysI have Cisco 1721 Router and have one serial and one Ethernet port. when i configure following commands for rate limit by trying on both the interface ( Serial and Ethernet) one by one rate-limit input access-group 110 25000 2000 2000 co...

Can I transport ethernet frames on frame relay PVCs ,, I know FR is WAN technology but is there any wayout to interconnect Ethernet over frame-relayRegardsfaraz

I have 2 routers, Marvin and champion. Both connected via Internet. But, Champion, 192.168.3.0 subnet does not seem to be able to browse Internet. Why?Marvin Routerinterface tunnel 0ip address 10.1.1.1 255.255.255.0tunnel source 203.1.1.1ip nat insid...

i am trying to forward the RDP port to a terminal server inside my LAN. but things are not working for me. Router is 801 ISDNmy config is..--------------------------version 12.1no service padservice timestamps debug uptimeservice timestamps log uptim...

I have set up a PPPoE ADSL connection on a PIX. I needed user name, password and the IP address teh ISP gave me. The default gateway comes from teh ISP using the PPPOE SETROUTE statement.How I am putting in a 2811 to replace the PIX. The connectio...

I have 3 circuits coming in to 3 WICs. These 3 circuits are in a multilink ppp group assigned to an mlppp interface. I have an inbound acl on the 3 individual serial interfaces as well as the mlppp interface. The problem is that the acl does not seem...

Hi,i have configured a policy routing on 3750 and tested to see if it work. But it does not work, if do sh route-mapi get this..no hits ?route-map www-test, permit, sequence 25 Match clauses: ip address (access-lists): 110 Set clauses: ip nex...

Question: Will the later versions of PIX Firewall (6.x) allow you to map 2 statics (outside) to the same internal IP address? In other words:static (inside,outside) 216.55.5.55 -> 192.168.1.2static (inside,outside) 192.168.1.2 -> 192.168.1.2 I'm runn...

All the show buffers pasted as followingBuffer elements: 491 in free list (500 max allowed) 18929063 hits, 0 misses, 0 createdPublic buffer pools:Small buffers, 104 bytes (total 1000, permanent 1000, peak 3970 @ 1w2d): 995 in free list (2...