Switches - Small Business

Six months ago, we kicked off an Internal vulnerability scanner (IVS) and the CPU on a couple dozen SG300 switches pegged at 100% and stayed that way. We could SSH into them, but they wouldn't reboot when issuing the command, so we needed to walk bra...

Any increase in MTU above 1500 across my SG100-16 is causing a reduction in data copy performance, although large ICMP packets appear to be unmolested.A system to system copy of a GB file at an MTU of 1500 achieves an average of 104MB/sec and the sam...

Hello everyone,   first of all I want to describe our network topology:   We got two SG550XG switches. One fibre switch which connects to our access layer switches (also cisco) and one copper switch. They're both stacked.   Attached you could find cu...

Hi, I have a SG350XG (firmware 2.3.5.63) here that regularly produces the following warning: Mar 12 07:34:57 192.168.1.46 %NT_GREEN-W-EeeLldpMultiNeighbours: Multiple LLDP neighbours on port te1/0/18 - EEE operational state is FALSE Port te1/0/18 is ...

HI I WANT A CISCO L3 SWITCH WHICH HAVE 24 PORT 10/100/100 BASE T PORT AND 4 GBE/10GBE SFP/SFP+, HAVING STATIC&RIP ,STACKABLE UPTO 10 SWITCHES please suggest me the model of switch.

Hello to everyoneI'm currently trying to update the Firmware on three SG350-Switches. One is brand new (SG350-10P) and there I had no problems to step-up to the 2.4.5.71-Firmware.With the other two devices (SG350-28P and SG350-28MP), after uploading ...

Hi Experts, We have 6 Unifi AP Pro connected on a SG300 52 Port PoE Managed Switch. However, the link on the ports wont go up. We suspect its something in the PoE confiration of these ports. What should be the correct settings and what are the comman...

Dear, I have been buy Switch SG220-50. When I setup it to my network. Some Issue about DHCP server .I have DHCP server on Domain Controller. With two scope.1. Scope ip: 10.60.1.0 : When my laptop, pc connect to the network via cable to SG220, the lap...

Hi, I would to change management vlan on sg200-08 switch, so created in switch vlan 100, my port ge1 which is uplink to other switch is configured as trunk, then on Management ipv4 interface I choosed vlan 100 assignet IP, netmask and gateway correct...

Hello All,   I have three vlan in the switch Vlan 1 Data Vlan 20 Voice Vlan 90 Native   I would like to configure the port to take the vlan Voice but when I tried is not possible to put Switchport voice vlan 20   So I would like to help me How I can ...

Is anyone aware of a specific MIB for the SLM2008?I'm looking to monitor them with devmon