Switches - Small Business

Hi all,I undestand that there was added IPv6 forwarding to SG500 line of switches with the 1.3 series firmware.As this also planned for the SG300 line of switches? TCAM ressources are of course more rare on these switches but they should suffice for ...

Hi, distribution can´t tell me if rackmount kit 19" is included in 8-port models... can anybody tell me? Thanks a lot! 

 Hi,I am new to voice VLAN. I would like to make the network works like the diagram below. a phone connected to the switch gets a address on VLAN5 and a PC connect to the back of the phone gets an address on VLAN1. There is a DHCP server on VLAN5 on ...

Hello,I'm using for one part of our small business network a SG100D-08 EU switch.For an unknown reason, this switch is not working at one location. When connected to a laptop, the laptop is not getting an IP address.If I replace that Cisco switch wit...

HI,I upgraded Firmware on switch smallbussines 200, but I don't know how enable SSH.Could somebody step by step how will do that?

I am using an SFE2000 in a small business setting.  With nothing going on, the switch is reporting 100% CPU utilization.  lcli usage is very sluggish.  We have been experiencing some slowdown on the network, and this could explain it.The lights are n...

Hi,Some questions:1. Do we need to upgrade the boot code every time the firmware we need to load is 1.3.5 and above?2. What do we need to load first boot code or firmware? or any order will do?3. From the notes below. Do we only need to update the bo...

Hello,I wanted to know if the Microsoft Network Load Balancing can also be configured on the switch SG-500? and if so, how?

Hi all,The ports on my SG200-08 are configured as follows:Port 1; VLAN 1+4; trunkPort 2; VLAN 4; accessPort3-8; VLAN 1; accessThe config for Port 1 looks as follows: "switchport trunk allowed vlan add 1,4". The problem I want to point out here arises...

My network equipment sits in a home office environment.  I just replaced a Cisco Catalyst 3750-48G switch with two SG300-28 switches to eliminate the fan noise. The router between the LAN and WAN is a Cisco 1921. What is the optimal way to connect th...

There are two features I would like to see added to the 300 and 500 series to make them even more useful in small business deployments.   1.  The ability for the switches to act as DNS forwarders and to respond with entries in the host table to DNS r...

Hi allI'm configuring a new 10Gb/s switch solution (WS-C4500X-F-16SFP+) with DAC cables (SFP-H10GB-CU5M)  for our customer. He asked us a 10Gb/s compatible network card for his ESXi servers. I've looked several brand (qlogic, intel, broadcom) but I'm...

How to reset factory default mode of Catalyst Express 500 Series Switches.I am using Windows 7 Laptop. I was keep on trying to reset using this guide link.(http://www.cisco.com/c/en/us/support/docs/switches/catalyst-express-500-series-switches/70874-...