Switches - Small Business

Hi!We considered using the SF100D-05 Switches in small offices with an insufficient amount of network jacks. However, it appears that this switch-series is faulty. In the combination of new MSI-mainboards with Realtek network chipset, the link to the...

HI!I have a small network. I have 3 300-28 cisco switches. I already connected my 3 servers  and clients with the switch 1 and now I want to add more clients and I need to add my other two switches in the network. Please guide me with the simple conf...

Is there a way to upload a config file to a SF302?

Hi all.  I have 2 srw2024 attached using mm fiber and gbic adapters.  One of the switches stops passing traffic for 3 minute intervals several times per day.  yesterday, it went down 10-15 times.  I enabled all possible logging last week and found th...

I have been asked to source small office switches which are IL3 compliant. Does anyone know if the 500 is IL3 compliant, or if any other Cisco Switch offenings are?

Does anybody can help me with above topics?I would like to connect Cat 3750X-24T-S to SG500-52 Uplink (Combo RJ-45 Port).Thanks,Willy

I am attemptting to configure a SF500-48p switch to do the followingUse port 1 as VLAN 100, use port 2 as Vlan 200 both of these are untagged Vlans, then use port 3 as a trunk for both the vlans which would be tagged.I am attempting to use both the G...

I have 2 routers, both cisco one is a static IP and has no issues, the other is a dynamic IP and the router is a RV320, i know the rv320 has two wan ports, I'm getting limited connectivity on vlan 4 and 5 that are on the RV320, attached is a photo of...

 Hi There, I have a SG300-10MP, running in L3 Mode. connected to a ddwrt modem/router (to be replaced in the near future) 192.168.32.1latest firmware, & 3x NetworksI am having issues routing between the VLANs and connecting to the Internet (or even t...

I have created static hosts for all of my clients (interim measure until I get DNS servers built and running) on an SG300-20. I defined all of these allocations using MAC addresses.However, several of my clients (1 Windows 7 workstation, 2 FreeNAS / ...

I am trying to do the following:SG300-20 segmented into 4 VLANs - call them "clients", "servers" and "printers" along with the default VLAN that already exists on the SG300 at startup. SG300 is already in Layer 3 mode with a virgin (reset) configurat...