Switches - Small Business

I created my network in the following order:Set up an RV340 router, using its GUISet up an SG350 switch, using its GUISet up a few 140ACs, using the main AP's GUIInstalled a Cisco Business Dashboard (CBD)The CBD discovered the existing equipment:Requ...

Hi,We need to setup over 200 access rules  and we have an error message that the maximum number of rules is 200 entries.  Is there a way to increase this value? Thanks

I've connected recently on an SG500X and an SG500  several devices and all of a sudden the port VLAN settings change to default, PVID1, and Tagged all available Vlans. In an instance, I connected a Yeastar PBX on an untagged vlan40 port, and all of a...

 Dear all,kindly allow support for a switch newbie like me: A. HARDWARE. German type router [Fritzbox 7590 with OS 7.25] and NTP server functionality enabled.. Switch SG350-28P 28-Port Gigabit PoE Managed Switch and firmware 2.5.7.85 updated. both in...

I have three sx350x-52 switches, all are running firmware version 2.5.5.47. These are free-standing, meaning not in a stack. Each of the switches is connected to backup power. Only one of the switches reboots itself. The logs show nothing to indicate...

Hi everyone, I have a Catalyst 9200.I set the vlan inside the switch :vlan 11 -10.11.1.1 255.255.255.0vlan 91 - 10.19.1.1 255.255.255.0vlan 92 - 10.19.2.1 255.255.255.0vlan 93 - 10.19.3.1 255.255.255.0vlan 250 - 192.168.250.254 255.255.255.0 I set th...

I have a pair of SG350X's connected with a trunk. The trunk configuration is: 1T, 68T, 10T, 11T, 999U To each of the switches is configured a network device from Hirschmann. These devices communicate with a proprietary protocol which requires tagged ...

Dear all,kindly allow support for a switch newbie like me: A. HARDWARE. German type router [Fritzbox 7590 with OS 7.25] and NTP server functionality enabled.. Switch SG350-28P 28-Port Gigabit PoE Managed Switch and firmware 2.5.7.85 updated. both in ...

We have an SG250-10P switch connected to Aruba Instant APs.  The switch does not seem to be providing the adequate level of power to the APs to activate the radios.  Are there specific settings associated with the switch to set the power level for th...

Hi all, we are configuring our first SX350 Cluster and then we are testing some simple things. First of all here is our setup :   - 4 SX350X 52   - Unit 1 is linked to unit 2 using 2 copper cables   - Unit 2 is linked to unit 3 using 2 fibbers   - Un...

Setting up first CBS250, replacing an SF302 which has gone bad, and not able to get DHCP to pass through VLANs.I have a Trunk setup on CBS250 Fiber port, on other end is existing SG300. VLANS Untagged and Tagged match on both units. However DHCP pass...