Hi, I'm about to update two 9400 switches, one 9410, one 9407. Going through the 9410R downloads section recommends 17.9.5 as the latest mature release. However, the supervisor module download page suggests 17.12.4.
Hello, all.On a couple of stacks, when I run "install remove inactive" I get the following message:install_remove: START Thu Sep 12 12:02:24 EST 2024FAILED: install_remove : The input file INVALID is not a valid fileIt is version 16.5.1a.Here is the ...
Does C9500-48Y4C-A support both SFP and SFP+ RJ45 module? Have checked the https://tmgmatrix.cisco.com/?npid=50 Cisco Optics-to-Optics Interoperability Matrix for combability, it is on the list. But from Cisco commerce online configuration, there is ...
we need to carry out simulations in the laboratory and consequently allocate memory or CPU at 90% as the DNA Center has been unable on several occasions to detect this condition in the Catalyst 9200 and 9300 series switches while other SNMP monitorin...
I'm working with a Catalyst C9500-32C on version 17.1.1. I have a QSFP-4SFP25G-CU5M module in port 2(the port is breakout enabled). Cisco Optics-to-Device Compatibility Matrix shows that QSFP-4SFP25G-CU5M is compatible with C9500-32C on version 17.1....
hi, can anyone please help advise how to find out the maintenance contract based on the switch serial number? I used the following tool to check warranty status, but can't find the contract number and the details of the warranty, thanks in advance.De...
Hello all,I've got a puzzling issue with a particular mac address not being learned over a trunk on my core switch that is present on the access switch's tcam table it's connected to, despite other MACs also being learned over the same trunk on the s...
We are moving to Cisco C9200 Access switches with a Core C9300. Our environment has Avaya IP Office with physical phones on our desks. With our existing Avaya switch, the port the phone connects to is configured with two VLANs. We have VLAN 20 for PC...
Hello Anyway to configure the C9500 switches SVL with essential license.Appreciate your helpThanks
I'm looking to replace a pair of WS-C4500x-16 switches, possibly with a pair of C9500-16x switches. My question is, when configuring SVL on the new 9500 pair, could I use the two 10/100G interfaces for SVL configuration and then use one of the 1/10G...
We have a managed router solution on our WAN. We don't have direct access to the router, configs, logs, etc. (Inherited this design).MRS <-> C9300 (layer3)At each location the C9300 switch is also configured as the DHCP server.At one location, the pr...
I am trying to configure EMM but the option to configure track is missing? Please help, thanks in advanced.
Greetings, I have two 9300 switches in stack. When trying to create a vlan. IPv6 commands are added automatically to the interface. I have tried removing the commands manually but they are not getting removed. ipv6 address dhcp,ipv6 address autoconfi...
Hello to everybody.This issue is with the interfaces nexux,. New device new cable, and sfp all newOne side doesn't come up . I changed the negotiation to auto at the same problem; does anyone know why?Nexux 1Et1/48 connected trunk full 10G SFP-H10G...
I have a 9500 series switch in VSL stack and trying to do a packet-trace on it to see how a packet is handled in the FED. I have made an Embedded Packet Capture on a port on the switch and have captured some packets in a PCAP file. When I want to "re...
