Switching

HiWe are looking for recommendations for replacing our existing N7K.Is someone able to guide us in the right direction...This is the current build:Mod  Ports  Module-Type                         Model              Status---  -----  ------------------...

Hi, I have a Nexus 5000 Switch sat between 2 Routers on which I'm trying to configure Private Vlans. Vlan 1111 is configured as the Primary Vlan configured on the Upstream Port (Eth1/21) to Router A, Router A is configured with an IP address of 10.1....

The customer who we are working with wants cisco products to be manufactured in certain countries or has a list of countries where they do not want cisco to be manufactured. The products need not be TAA compliant but they can be CFIUS compliant which...

Goodmorning everyoneI hope you are all wellCould you please help me with this?I am trying to program a smart home with a few conditions to specify how the humidifier should work should temperature's in the room simulation fall below 20 degrees celciu...

Hi all I've a few research in interface OID on Cisco IE3200 (not specifically only this one) Just looking for is there possible to get broadcast on bits (bps) instead of pkts ?   Here's some detail # show storm-control Those value would got by 1.3.6...

Hi All, Does anyone of you know how to disable AppGigabitEthernet on Catalyst 9400 series? Thank you.Is AppGigabitEthernet enabled by default?

I am trying to get a 100Mbps fibre port for SMF(Single mode fibre) from the above switch using a GLC-FE-100EX SFP.But the switch is detecting SFP as 1000 Mpbs . Is it possible to change the speed to 100 Mpbs while using this SFP, I couldn't find a wa...

I have searched for an answer to this one for quite some time. Unfortunately, the below configuration isn't taking care of the issue for me. Anyone have a "silver bullet" I can use on this CVE?What I have tried (most recently):ip ssh serv alg kex dif...

CMICR-4PT SFP port (7) not showing in the list of available ports.Switch Ports Model  SW Version  SW Image------ ----- ----- ---------- ----------* 1 6 CMICR-4PT    15.2(8)E1    CMICR-UNIVERSALK9-M

Hi All, I have been facing some critical issue on my ASR 1002 Router which is reloaded automatically and when i saw the reload reason in "Show Version" then its mentioned this reason for reload ASR Router " critical process fault, fman_fp_image, fp_0...

Hi, I would like to check what could be causing a stacked switch to crash/hang and needs restarting frequently. This started after we upgraded our stack of WS-C2960X-24TS-L from 152-7.E4 to 15.2(7)E9, and this still occurs after I've replaced the swi...

i have router the model of 2811 and also switch which is power over ethernet (POE). two ports of router which is fast ethernet port and switch have 24 ports fast Ethernet and 4 Gigabit Ethernet port SFP. the issue is that i have use the port of route...