Can LACP priority help to make PO31 the active etherchannel over PO30 in my scenario? Image attached.
Both LACP are currently setup with default priorities.
Thanks!
Dan
I've been testing 2 C6840's, I would like to reset them back to defaults from out of the box. Is there any documentation on how to accomplish this. Thanks.
We have cutover to the Cisco Business Edition 6000M Svr (M4), Export Restricted SW (BE6M-M4-K9=) for UC. Two ports on this server are connected to our 2960S switch stack . The Server runs VmWare ESXi and the VMs related to UC – Communications manag...
Hi,
I erased the config file that the router came with and could no longer get to it through a browser using the default of 10.10.10.1
I've tried to cofigure back to how it was by assigning the 10.10.10.1 ip address to Ethernet port 0 and enabled htt...
Hi,
I would like to address this, if find it very weird.
Set up:
Management - VLAN1
User - VLAN 1
So the thing is if your management is intermittent and if its the same vlan with your users, it will also be intermittent right? Since you are in t...
We have cutover to the Cisco Business Edition 6000M Svr (M4), Export Restricted SW (BE6M-M4-K9=) for UC. Two ports on this server are connected to our 2960S switch stack . The Server runs VmWare ESXi and the VMs related to UC – Communications manage...
I have a CISCO 2960X Access switch which is configured in 3 Stack.
IOS Version 15.2(3r)E1 Software Image: c2960x-universalk9-mz.152-2.E5
The System is connected VIA the CISCO IP Phone and then terminated to the Switch (Including the Patch Panel).
Bu...
I keep seeing these messages in my logs very frequently on a Nexus 5548UP. %LLDP-3-DETECT_MULTIPLE_PEERS: Multiple peers detected on mgmt0Anyone have an idea of what might be causing these? Google has shown less than desirable amounts of informat...
Hi,
I have a cisco 1841 router and Switch Jnuiper ex2200-24T. I have created new vlan for set of users and advertised that subnet in bgp. Please let me know how to pointing the reverse route of new VLAN subnet in router pointing to switch.
Hello, as part of our normal switch build I notice these two commands are to be placed on every switch access port:
switchport block multicast
no ip igmp snooping tcn flood
Are these two commands really necessary or recommended as standard procedur...
Hi
I got a bit of a peculiar problem which is driving me up the wall
I recently upgraded a C3850 24t x 2 stack from 03.03.03SE to denali 16.3.3.
Ever since our client teams has not been able to discover the thin/thick clients using option 203 on...
Hi,
I'm trying to analyze for the network at the new company.
I noticed that all the routers and switches aren't enabled CDP...
How should I analyze the network in a prompt way and easy way.
I will very appreciate if you can help help me.
Thank y...
Hi there!
I have some questions about configuring QoS on the 3850's. We use them as Access-Switches and have a pair of 6840's to aggregate them. We only have L2 on the 3850, routing is done on the 6840's.
Now, i need to configure QoS in the LAN and ...
Hi Team,
I want to migrate HP 2510 to Cisco 2900 series . I need your support regarding 802.1x implementation for Cisco 2960 and we have Microsoft NSP for dot1x. Could anyone guide me further about it and I prepared the following template :-
E...
