Switching

Hello, What is the benefits of Ipsec over GRE ? I understand the "standard" GRE over IPsec to provide security and etc. But what is reason and benefits of using  IPSEC Over Gre ? Thanks

Hi all,, Can anyone please explain me the OSPF LSA types applicable for Cisco Devices,, 1.Router LSA 2.Network LSA 3.Summary link LSA (Generated by ABR sends update to opposite area) 4.Summary Link LSA (Generated by ABR sends updates to opposite area...

Hello, I'm using a 1941w router and the default gatway to access the gui through a browser is 10.10.10.1 . As I'm new at using it I was learning how to do things and so to make things go back to normal I looked at how to reset and erased the nvram. N...

Hi, I am trying to update my ESXi from 5.5 to 6.0 using the esxcli but I receive the error -   /vmfs/volumes/4f0a37af-1ff59fa8-c5d8-001018a76a5a # esxcli software profile update -d /vmfs/volumes/4f0a37af-1ff59fa8-c5d8- e-from-esxi6.0-6.0_update03.zip...

Please excuse my ignorance here, I am relatively new at this switch and router management. Historically I have been in security, but the guy who normally handled this left rather unexpectedly. We have 2960's spread across three states in different lo...

Hi All, I have configured Flexible Netflow on CISCO 3560X Switch. Configuration as Follows: flow record netflow-to-orion match ipv4 tos match ipv4 protocol match ipv4 source address match ipv4 destination address match transport source-port match t...

Hi, We are receiving the below error on our Cisco 3850 switch,     *Jul 19 12:06:02.332: %ACL_ERRMSG-4-UNLOADED: 1 fed:  Input IPv4 L3 ACL on interface Vl57 for label 29 on asic255 could not be programmed in hardware and traffic will be dropped I w...

We have ASR1004, es works till the module SPA-1X10GE-L-V2  not started and gives always following errors. Error (3) CMCC-3-PLIM_STATUSSIP0: cmcc: A PLIM driver informational error RXSPI0 DIP4 Error, block 13 count 7 Error (3) CMCC-3-PLIM_STATUSSI...

I see that the DRAM requirements for the software to run the 10gb service module is 1024mb. When I read the spec sheet, it shows that the installed DRAM is either 256mb or 512mb, depending on the model.  Can this module run with only 512mb of DRAM or...

Historically in the network that I work loopbacks are configured with /32 mask and with "ip ospf network point-to-point". I understand that "ip ospf network point-to-point" is useful when one wishes to configure a network with a shorter mask on a loo...

I donot have cisco username and password but i want to download  Cisco Network Assistance please tell me and guide me Help for download this software

Using a 3750G stack with the release 12.2(44)SE5 with Ip services feature set. We have configured EIGRP on a switch stack with redistributed connected using a route-map. Though in the route-map only 1 SVI interface is specified all the SVI interface...

Hi, We have configure the etherchannel in our cisco 2960-X to SG350X successfully with 2 x 10G SFP+. In 2960X we are able to see the BW (bandwidth of 20000000 kbit/sec using the command show int po1 However when issue show int po1 in SG350X it only d...