Switching

Can someone shed some light on the following N7k EIGRP command:{ip | ipv6} offset-list eigrp instance-tag {prefix-list name| route-map name} {in | out} offsetI have two neighbors connected on the same LAN segment/Interface VLAN.  Right now I am learn...

I have two sites that have a fiber run between themim using a sg500x 48p andsg500 28 p they both have a MFEFX1 module ive put the mfefx1 in the xg3/s1 expansion port on the sg500xand on the s500 I've put the module in g27/s3 port. first question thes...

I got one side of my lacp port channel down. the topology is shown but the left side is showing down 20    Po20(SD)    Eth      LACP      Eth1/5(s)    Eth1/6(s) # sh int port-channel 20port-channel20 is down (No operational members)  Hardware: Port-C...

Dears,how can we  apply an access list for telnet and ssh on asr 5k ?please advise if this is feasible.thx.  

Hi allWe're in the not very comfortable situation that our WAN service provider will accept only a very small set of DSCP values to assign traffic to their "Classes of Service".Our 2960s are directly connected to the carrier's CPE, and on that link w...

HiI have edge switches connected to core switch using trunk. We have attached cisco Ip phone to end switches , we are going to deploy QOS . As below we implemented auto qos voip cisco-phone under cisco access switches interfaces and under trunk we di...

 Hi All, Kinldy let me know that #sh ip ospf route, which IOS Version support this command... RegardsIndrapal

Please i want to know if the GRE tunnel has limitation for traffic passes over it depend only on physical media. Example:if i want 5GIG traffic to pass over GRE tunnel and physical media have BW 10 GIG ,GRE tunnel can handle this amount of traffic or...

Does 2960-X with LAN Base supports static route?

I am configuring voice vlan on a Nexus5020 version 5.2(1)N1(8b).I am getting the following error message:nx5020-wc0(config)# interface Ethernet1/15nx5020-wc0(config-if)#   description Guaritanx5020-wc0(config-if)#   switchport access vlan 2nx5020-wc0...

i will use a switching module in 3945 router instead of 2960 switchexisting ios version(old-switch) is 12.2(44)SE6new ios version(new-sm module) is 12.2(55)SE7existing ios version mab do work fine, but new ios version mab don't work--- existing confi...

Dear all, Currently i have switch 3750 2 units and now it's running with stack and power stack cable.and i want to upgrade the New IOS to 15.x.x . is it have any problem when i upload the primary stack ( switch )? could you let me know the step to up...