Switching

After manual reload appears this message:*Jun 28 08:05:09.675: %SYS-SP-3-LOGGER_FLUSHING: System pausing to ensure console debugging output.*Jun 28 08:05:08.335: CM file (ivfs:/s72033_sp-advipservicesk9-m_matrix.cm) is not readable, using internal ma...

I plugged something into a new swtich (2960) that somone setup. The port lit up amber and never became green.I clicked the mode button to duplex and the port became green. After about 30 seconds the switch went back to its old mode setting and my por...

Hi need your helpon enablingSlot      Type                State                 Insert time (ago)0/1      SPA-4X1FE-TX-V2     out of serviceSlot      CPLD Version        Firmware Version--------- ------------------- ----------------------------------...

Hello,Our Internet router is a 2800 and has 2 fast ethernet ports and 2 serial ports.  However only one of our Cisco switches has a route to it, what would we need to do to link the other Cisco switch to it as this will give us some redundacy?Thanks

Hello,How many SVI (Switched Virtual Interfaces) it's possible to configure on Supervisor 6-E and 6L-E with LAN Base software?Please confirm me with a link to the appropriate site on cisco.com. Feature navigator do not show this information.Kamil

Hi,I have a SIP software, whose name is "Zoiper". I can configure in SIP client to have a DSCP value for signaling and media. I attached a picture with the options about this.In my network lan I want to apply QoS to prioritize this Voip traffic.I am ...

Friends,Can I have the Cisco URL to check the laltest IOS version for all devices / all models (switches and Routers & Firewalls)Thanks,Tamil..

I have a Catalyst 6509 with an ACL that includes a range of IPS with a route-map that work properly.When you try to add more sentences to this ACL including another IP range, we have seen that new IPs do not work correctly, then removing the ACL in o...

Hi,i have some 3750E switchstacks and use snmp to monitor the bandwidthusage. Sending the snmp-requests - in fact I use the oid's 1.3.6.1.2.2.1.16.101XX and 1.3.6.1.2.2.1.10.101XX (in/out octets) - to the stackmaster works fine and a clear graph is d...

Hi,     how do I grant privileges to non-privileged user, so he can shut no shut a specific     interface in some access catalyst switch like 2960?          thank you in advance - benzi