Switching

i want to build a local user (no TACACS!)that is able to make all show commands (with for example "sh run") but isn't able to make "conf t"so this user can only read but not write !!!What Priviledge is needed for this user?Do i need "priviledge exec ...

I have a dumb (unmanaged 8-port Linksys Gig switch) which we are currently using for some linux clustering servers. It works fine, but I want to move the servers to our 6500.  When I moved them from the switch to our 6500, the cluster breaks because ...

Hi,I've got a little lab pod on gns3 very simple, all are routersLAN---Branch1----FR1(Frame Relay Switch)---WAN1----switch---Core1Branch1LAN ip address: 10.1.1.1WAN ip address: 193.10.25.10WAN1:Interface pointing towards Branch1 (multipoint link) ip ...

Trying to create a Etherchannel wtih sub interfaces to support VLAN inter-routing between 3825 ESM module to 3750 G 1RU switch.  I can create the etherchannel between the 3825 and 3750 without subinterfaces and etherchannel works fine and can assign ...

Hi All,I needed the show command to see the tree structure for all VLANs in CatOS switch running RPVST+. Please can someone help me with this? Below command gives only VLAN1, any single command to give the below details for all VLANs? Need it ASAP.sh...

Hi All,I am getting the output erros in the switch interface:-sh int gi 1/37GigabitEthernet1/37 is up, line protocol is up (connected)  Hardware is C6k 1000Mb 802.3, address is 0005.7443.9ea8 (bia 0005.7443.9ea8)  Description: Connected-to-NokiaFW  M...

Hi,If switches do not have the mls qos command what happens to incoming packets that have a DSCP or CoS value configured?  Do they get reset?Also, if a switch does have mls qos command, but an interface is not set to trust DSCP or CoS, will any marki...

I'm "new" to QoS policing, and I thought I had this configuration working, but turns out it doesn't.  I was hoping to apply this policy for users on vlan 2099 both ingress and egress, but turns out the ingress doesn't work.  I modified the config and...

I’ve got Catalyst 3750 switch. On the ingress port (Gi1/0/4) I am receiving lot of traffic from some Voice equipment.  This is the configuration:interface GigabitEthernet1/0/4 description "media" switchport access vlan 113 switchport mode access serv...

Hi,I would like to create management network in my environment, currently we have 3750 and act as layer 2 for other vlans(DMZ,Internal), can i create new manemennt vlan that only act as layer 3 ( enable ip routing) or if i enable ip routing  will it ...

Hi Guys this is a requirement that my teacher assigme, I can´t do it... is posible?-L-1 and L-2 they must communicate via the ethernet  shared by "S-AR to Central as primary path, while the serial connection between R-1  and R-2 will be as a backup p...

I'm trying to rate limit  traffic on vlan1 for less than 1 mb. I use the following config and tried topush upto 6mb with the hope that higher than 1 mb will be dropped but it didn't happen in my case.when I do show int vlan 1 rate-limit I don't see a...