Switching

Hello,we have a stack of two 3750 (one 3750G-24TS and one 3750-24TS) with the latest image (12.2(50)SE2) installed.Now it seems that we are facing a quite fast memory leak (see the picture attached).I checked the services for two days and I think I f...

I'm about to remove VTP from all our switches. My plan is to change the Client switches to Transparent mode and then remove the unused vlans. Doe this seem OK?

I have known that each IP have only another MAC address number. But actuality, another result appears on the router when I enter commend " show arp | includ 001a.2f85.4abf ".Please refer to below logs.Router#show arp | include 001a.2f85.4abfInternet ...

I am considering a PBR solution for a 4500 series switch to selectively forward packets to a directly connected Cisco WAAS box. I need to know how PBR will detect if the next hop (WAAS) is unavailable in failure scenarios. My research shows that th...

I have two 6500 switches as core and running hsrp. i need to create one L2 VLAN and don't want inter-communication with other Vlans. i also need running HSRP. how i can get it. because if create one Vlan and don't create it's SVI interface it is what...

In catalist switch mac address table aging time = 300 sec (by def, and we dont change it). But on practice, we observe that mac address stay more than 5 min in this table (appr - 9,5 min)!why this occurs?!

I have two 3750 switches. Each have VLAN 91 and VLAN 804. From one switch, I can ping the other using VLAN 91. When I try pinging VLAN 804 from one switch to the other, I cannot get through. I believe I have all the correct routing statements in the ...

I have two 3750 switches, each with their own IP and configs. I'd like to join them together as a GigaStack, but I'm not sure which one will be chosen as the master. To force one switch to be chosen as the master, should I configure the stack member ...

Here is the scenario. Vlan 1 - 192.168.0.1/255.255.255.0Vlan 2 - 192.168.3.1/255.255.255.0Vlan 1 - Office LAN TrafficVlan 2 - Public accessVlan2 has Cisco 1130AG AP running on it, sending through to 192.168.3.0 for the DHCP (2 pools setup, one for ea...

Hi,Its my 1st experience to team network card and configure the switch.Server has two network cards but without teaming software. Server is connected to Cisco Layer 2 Switch ( 2900 series ); Is it possible to combine the interfaces, if Yes what steps...

Hi,In my topology i have four servers with two 3750 switch.Two servers are connected to Switch-A and another two servers are connected to Switch-B.Now i want achieve loadbalancing between switches like both in Active-Active(50%-50% load sharing) and ...

i have 2 bldgs connected with a layer 2 8mb link, plugging into a 100mb port of a 3560 at each end. I would like to shape outbound traffic to 8m and make sure voice gets transmitted in priority queue. with llc, only occures when 100mb port is conge...

Hi,Am getting input errors in Cisco switch 6509 and is connected to another swicth 6513.When i tried to ping each other , sometimes there is no packet loss but am getting packet loss and input errors mostly.Confiration is something like this:6509:Int...