Switching

The matrix in the RPS2300 documentation states that you need two 1150W power supplies in order to be able to support two C3750-E switches.I understand that if you are using POE on the switches. If you aren't doing POE and only have a 265W power supp...

3750 runs low memory too often. The current memory is 128MB. Switch almost fully populated with ip phones/PCs. Is this an IOS bug? Running IOS is C3750-IPSERVICES-M), Version 12.2(25)SEE3

Hi guys,I am missing something here, need your help/advise on this.From my LAN router I can do the trace route to my esrver located in another site. However from the same router, I am not able to do the source based trace route from one of its interf...

Is there any CLI command by which I can monitor/view the traffic flowing through Cat6500.

Hi ALL:Happy New YearI am getting this error when trying to copy the run to start up could any one explain the reason.Router#copRouter#copy runRouter#copy running-config stRouter#copy running-config startup-configDestination filename [startup-config]...

Is there any difference in the follwing:IE Police vs Police CIRpolicy-map 1class 1police 8000ORpolicy-map 1class 1police cir 8000

Hi!,I'm designing a solution that requires VSS 1440 implementation. I have a Catalyst 6513 with line cards as follow:WS-X6066-SLB-APCWS-X6324-100FX-MMWS-X6348-RJ-45 WS-X6548-GE-TXWS-X6148-GE-TXI don't want replace these modules, but these modules don...

Hello,I am new to cisco routers and switches but i've been trying to find out how do i upgrade my cisco IOS on all of my routers.i have 3 cisco 2620 with IOS 12.1(5)T10 and 1 cisoc 3640 with IOS 12.1(5)T10i've been told that i need a cisco smartnet i...

192.168.136.15192.168.136.31192.168.136.63192.168.136.127what is the brodcast address of this interface if the show int fa0/0 showsinternet address 192.168.136.200.23 / 28can anyone explain pls Thanks

Hi,Any advice appreciated. I have a new un-configured - 'out of the box' 3750 switch. I want to add this switch to an existing switch stack. Is it as simple as just adding it to the bottom of the stack with the stackwise cables? will it then receive ...