Switching

HelloI have a 6509 switch that has a .1q trunk to a 2960G command switch with 2 members. I replaced an unmanaged hub with a new 2960 (non-G) and established a trunk back thru the 2960G ultimately to the 6509. The issue is: I can statically assign ...

Hey there!,I logged into my router and my EIGRP network lists is gone! Does something happen to make it go away?If i go into config mode and add the networks back, would that be all that i have to do or is there something else?HELP!

Hi,I am not able to upgrade the IOS for 2621 router.Please advise.------------------ show version ------------------Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-IK8O3S-M), Version 12.2(11)T, RELEASE SOFTWARE (fc1)TAC S...

Hi Teamplse let me know any method or command to check the power utilization/consumption for 2900 series switchs. as this series switch does not support show power command.How can we check the same.RegardsVaibhav

Hello,Cisco is offering a huge choice of routers and since i am no professional in the field i would need a bit help on selection the right product.I am looking for an advanced router with about 8 ports, mainly for profound Internet traffic control, ...

Hi,I have 8 cameras, each is 1GigE setup with data output of 63-95 Mbytes/sec. Will need to run all 8 at the same time and continuously. How should i setup to link to a PC? Total data flow is around 504-760 Mbytes/sec to PC.Thanks.

Hi All,When I connect my Laptop to Cisco 2960 switch port, It acquires IP address after 45-50 secs, sometimes it gets timed out.it dosen't happen when I connect to a nortel port.Could anyone suggest what can be changed in the cisco switch configurat...

how i can configure like this type of vlan communication...vlan10 communicate only vlan20 ,vla30,vlan40,vlan50 but vlan 20,vlan30,vlan40,vlan 50 not communicate each other .

Hiwill clear top all on 6500 catios will do any interrupt int he network'i have done show top 5 pktsif this running is there anyharmredsADHi

I have 2 vlans on cisco 6509 catalyst switch as follows:IT Vlan: 10.10.14.XTest Vlan: 10.10.29.XI have conigured the interface for the test vlan and connected a Unix Server to it but the server is not reachable. I connected windows pc to the same int...

hi, Scenario: Dual Cat 6500 chassis connected via trunk. All the vlans on MSFC have SVI configured with glbp as belowSwitch 1interface Vlan8 ip address 1.1.1.1 255.255.255.0 glbp 10 ip 1.1.1.10 glbp 10 priority 10 glbp 10 preemptSwitch 2interface Vla...

DearWe have 3750 series switch.we configured8 to 10 vlan on this switch.We have 71,72,73,...90 vlan.We want to configure our 71 vlan will not talk with another vlan so please tell me how can we configure

Get the following message while a 6509 is booting up:- RELIABILITY DRIVER: wrong signature on NVFLASHIt continues to load and becomes operational.However, would obviously like to find out what is causing this message. Its a 6509 720.