Switching

http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a008019e74e.shtml#maintask1I was reading over the howto at the above link, and I got hung up on step 6. Are they talking about a default gateway/gateway of last resor...

Hi All,On 3560 switches, iam looking for a link with below information...1. Back up existing Flash image to TFTP server2. Upgrade the existing Image.Thank you in advance.MS

I have started in this company for 4 days now and have been given a task that has already been started by two other engineers but they had left due to some issues and now I have been brought/hired and been given this project. I don't have any backgro...

Hi everyone,I'm new to this forum.I've got a question regarding port status.I want to know what the most effective way to see how long a port hasn't been in use?I'm using web based "CiscoWorks"Thanks!

I am trying to connect the new 6509E switch with 3750 using SFP module. 6509E is running 12.2(33)SXH and has a SUP720-3B and 3750 is running IOS 12.2(25)SEE2. We can't seem to establish the connectivity using port-channel or single port. Port is prop...

I have a CAT6509 with MPLS.. two redundant MSFC2 blades. Whenever I go in to configure one of the MSFC's I get the message:%MROUTE-4-MTU_MISMATCH : WARNING: With IP multicast enabled, interfaces which transmit traffic from larger to smaller MTU inte...

Hi,I have a 2948 switch with an IOS that i am fing it difficult to use,most commands are not the conventional ones,Could any of you give some guidance on how i can do this upgrade?

Hi there;Can anyone tell me when you would use an FXS card to connect to a PABX rather than a FXO card? Can an FXS card be used with a PABX?Regards

Hello To all,I was wondering if you may please explain to me what stands behind the network 0.0.0.0 0.0.0.0 command if put under ospf/eigrp config? and how will this command effect redistribution?any help in the matter would be greatly appreciated.Be...

I recently introduced VTP pruning on a LAN, and now I have some connectivity problems on certain VLANs.1. Is pruning based on whether the switch has any active access ports or unpruned downstream trunks on the VLAN? Or is it based on whether there a...

Hi,I have got a cable modem (model above) connected via ethernet to a C871 with 1 Fastethernet port and 4 L2 ports.I have configured the following so that I can ping the gateway of my ISP. I have been given a static IP address.Router#sh runBuilding c...