Switching

Hi. Please forgive my lack of knowledge regarding QoS, but I must ask for help. I am supposed to get QoS configured on 11 switches at an elementary school in our district. An engineer has been hired to set it up at the other buildings as they were...

What is the significance of command "no scheduler allocate"Thanks.

here is the base info:Session 1---------Type : Local SessionSource VLANs : Both : 2-3,104-107,110-111Destination Ports : Gi1/0/5,Gi2/0/5,Gi2/0/15 Encapsulation : Native Ingress : DisabledCisco IOS Software, C...

i would like to route traffic out of 2 interfaces on an asa5520. the most recent interface GE0/2 is a cable connection. I would like to separate all http traffic to come and go on this port. I am using asdm to config. using the packet trace util i se...

Hi All,I`ve configured 2 NLB clusters in Multicast Mode.Cluster 10.0.16.130 (Node1: 10.0.16.131 Node2: 10.0.16.132) Cluster 10.0.19.2 (Node1: 10.0.19.3 Node2: 10.0.19.4)I must give network access to these clusters.One cluster is connected to Catalyst...

I use Cisco 2611 XM for my existing setup of IPLC-VOIP technology with a 4 voice extensions, I plan to increase the number extensions to 8, Is my existing model is compatible for this increase ?

hi,i have a catalyst 3560, i do by error: 'erase flash'so i'm erased the ios.how can i copy the ios on switch?thanks.

Hi,This is my configuration, web browsing works but I do not know why nat does not workBest regards

Hi, i am facing pvid inconsistancy and type inconsistancy problem in my network. network connectivity Sw1----------------Sw2--------------Sw3 sw1 is cisco siwtch(spanning tree mode pvst+) sw2 is extreme switch(spanning tree mode is CST,it is work on ...

In a test lab, I have implemented a backbone using 4 6500 switches connected in a square configuration. The backbone is using MST, the four 6500 are in the same MST region. Then, i connected two 2950 switches to the backpone. The 2950 are not using ...

We have inherited a 2950 switch. The switch does not boot, and the console shows nothing. The SYST light flashes amber continously. Any assistance is appreciated!Bryan

Can you assign multiple route-maps to an interface. My IOS doesn't seem to let me. I'd like something to the effect of:If destination is network A or B set next-hop X.X.X.Xif destination is network C or D set next-hop X.X.X.Xelse use normal rou...

Hi,When adding a VLAN to a VTP domain, is there a requirement to create the vlan interface on the edge switch that hosts the clients that belong to that vlan? I use HSRP between the two core switches so have currently assigned the following:-Switch A...