I just upgraded the IOS on a 2950, but now I need to clear out the old VLANs. Is there anything else I need to clear out so that I can start off fresh?
Hi, On my PIX when i am trying to execute command " crypto ipsec transform-set strong esp-3des esp-sha-hmac " i am getting output saying "VPN-3DES-AES is not enabled with current activation key." so do i have to activate key for this or i am missi...
Hi guys,I have a few Catalyst 2960 switches on my network. I would like to know is there a command that can be used to see what are the IP addresses of the computers connected to each port on the switch?I know it can be done via 3rd party tools, but ...
I have a requirement to tunnel 100Mbps through GRE. Has anyone successfully pushed 100Mbps using a Cisco 7200 through GRE? We have a total of 4 sites. Each have 100Mbps to the HQ over a service provider network. Customer wants to avoid having to ...
Hi, We found this IOS bug CSCeh02029 related to our problem. But I can not download the fixed the IOS version 8.5(0.39)JAC, 8.6(0.106)TAL, 8.5(0.130)JAC, 7.6(13.3), 8.6(0.171)TAL . They are not listed on Cisco wen page. Also this bug status is: More....
Hi,On CatOS 8.5,sh port mac utilization 8/1gives,5 minutes input/output port rates:How can I reduce this to,eg. 30sec?Like IOS interface command,load-interval 30Regards, MH
Hi, want to get more informaiton about workings of CDP. In particular about: 1) why CDP needs SNAP encapsualtion 2) does Frame Relay run using SNAP? 3) Some text says ATM does NOT support CDP some say it does?If someone enlighten me on this or refer ...
Hi, sorry if this is a stupid question:In my cat 2900XL, I configure both fa0/1 and fa0/2 as 'switchport mode trunk', dot1 encapsulation.I created VLAN1 and VLAN2. I want to have VLAN1 associated with fa0/1 (what it is by default). I want to VLAN2 as...
HII Have 2 servers(web-server & exchange server) with fake ip on my lan(10.10.10.10 & 10.10.10.11) as well a 2621 series router.i want to nat this 2 server to the public ip address(194.x.x.20)what could be the the config in my router as a NAT Config...
I am having problems where it appears that the 6500 is not learning MAC addresses correctly. If I do a ping from the MSFC on an 6500 to a device connected to another 6500 I would expect the MAC address to go into the CAM as soon as I do this but some...
