Switching

hi all, just a quick question about pix/asa's , if I want internet access outbound, do I just need to allow port 80 outbound and this will automatically let the pc that made the request back in ?

I have successfully configured a VLAN on a Cisco 2621 router using the following settings:interface FastEthernet 0/1.7encapsulation dot1Q 7ip address 192.168.7.1 255.255.255.0interface FastEthernet 0/1.8encapsulation dot1Q 8ip address 192.168.8.1 255...

Port FastEthernet0/0 on device Router with ifSpeed 10000000Port FastEthernet4/1 on device 6509Series_Switch with ifSpeed 100000000Severity report is Medium. Speed on switch isn't specified therefore it is on Auto.What are the pros & cons to this? ...

I have been wrestling with the best design for my network. I would like to take advantage of the MLS features of a 4506 but want to pass the traffic through my PIX. I would like to minimize the vlans needed off the PIX and have the routing take pla...

I have a quick question, is it possible to install a new blade on a cisco 4507 switch while its still powered on

When siffing my IP network I came accross Xerox-000000 producing a good bit of traffic. The sniffer did not pick up any more info on this. I have checked all the xerox printers and only IP is configured. Has anyone came accross this address before?

Hey Everyone, I am having some issues with my Switch/Vlans. Here we go, I have a couple of servers that i need to segment for a remote user. This user will only have a remote VPN to these 3 servers in the x.x.79.0 network in Vlan 20.. Here is wha...

Hey everyone. We had some serious issues between Building 1 (B1) and Building 2 (B2). And the only way we arrived at to fix them, was to put each in a separate VLAN.So B1 is 192.168.10.x, 255.255.255.0B2 is 192.168.11.x, 255.255.255.0Each site has ...

Dear Sirs, In the Cisco7206VRX chassis. Is processor redundancy possible? Best regards,

Can anyone explain the software release cycle for native IOS to me?eg - what's the difference between 12.2(18)SX1 & SX6 - is it just bug fixes?what's the difference between SXE and SXF?Why does it never reach GD?Cheers, Dom

I need to limit the bandwidth of Ethernet port of 2950 switch to 1 Mbps. Is there any option in 2950 for rate-limiting or traffic shaping by which the same could be possible.

Can someone send me a link to upgrade the IOS on a calalyst 3750.Thanks.