Hello,I need to discover an IP address for a device on a specific port(FastEthernet1/0/2 on a catalyst 3750. The switch and the patch panel are not labeled so I have no clue which devices are where. Is there a way to do this?ThanksRich B.
We have just started using the 2950 and have been told by two different people that if you hold the button down on the from of the switch for 3-4 seconds it does a factory reset, is this true?Is there anyway of disabling this feature as some of our s...
We have a 129.33.1.0/24 class C network assigned to us and we needed to carve out a subnet from this network for the serial port on the router. So, I used 129.33.1.1/30 and wanted to use 129.33.1.5/24 for the rest of the network. Well, this did not w...
I have a Catalyst 3550 that won't keep it's clock setting. Notice below, that when I set it, there is a dot pre-pended to the time. None of the other switches have this.cat3550p#clock set 18:42:00 Mar 12 2005 cat3550p#sho clock.18:42:05.379 EST Sat M...
hi everybody,can any one tell me about the real differences in L3 and router software features only (i dont want the differences between switch L3 and router).v. thanksthaar
Hello,We have configured a local dhcp server on our routers. The issue is that the people onsite are experiencing connections problems, after looking into the issue, we found out that sometime the dhcp server allocates a wrong subnet mask to the clie...
We need to span a port on a Cat-6506 switch. Can a source port and a desination port be on two different VLANs or do they have to be on the same Vlan?thanks.
Dears,We have a new Catalyst 6509 and the power cord is CAB-AC-2500W-EU. But I found the cord has no grounding connector. What should I do? Can anybody give me a advice?Thanks very much.Figure for CAB-AC-2500W-EU:http://www.cisco.com/univercd/cc/td/d...
Hello Everybody,I'm writing this new "conversation" because I'm in a "delicate" situation and I need some help.Delicate because time is always an issue, network installation has to be done and if I would not doit noew it will be very difficult to doi...
Hi,I am using 3745 router, When i debug anything lets say debug crypto isakmp it doesn't show me notifications on the screen,Till 2 months back it was happening perfectly fine..All of sudden it stopped.Any help will be appreciated on the urgent basis...
Hi all,I do have a question regarding the backplane capability of the 3750 switch. I know from the CCO docs that it has 32 GBps backplane capability. My question is as the stack increases, does this mean that it still has the same 32 GBps backplane...
I'm trying to get NAT-PT support working on a Cisco DSL router to support native ipv6 clients behind it. I've done a lot of searching, and can't find the answers to what I'm doing wrong. I have two problems.First, I can't get them to grab additiona...
