Activity in Technology and Support
L2 to L3 Network design in datacenter using eBGP
Folks, We are running EVPN/VxLAN in our fabric and now time to scale so I am thinking to run FRR daemon on all the linux servers and peer them with TOR leaf switch using eBGP and create full L3 end-to-end network. It allow me to remove LACP from swit...
Podcast files being blocked (Spotify / Megaphone)
Podcasts hosted on the Megaphone.fm service (owned by Spotify) are being blocked by the OpenDNS Family Shield service. Anyone else seeing this?
Cisco 4351 with three ports and one connects to the internet.
I am recently retired from IT, with NO routing experience, so don't be surprised if I say something anything that is incorrect. I'm working on a home lab to isolate my experimentation from the rest of the house and I have a problem - my Cisco 4351 ha...
Can not apply a Deny ACL on PBR on Nexus 9K
Hi I am currently using my SG350XG but am going to move over to my Nexus 9K C93120TX. On my SG, I have these settings for ACL/PBR/vlan8 which works; ip access-list extended SL deny ip 192.168.0.0 0.0.255.255 192.168.0.0 0.0.255.255 permit ip 192.168....
Cisco QOS full solution
Dears, I have a customer who has an issue with voice between two branches; the WAN link is utilized at peak hours of the day. I need a full QOS conf end-to-end from the access switch to the WAN router Does anyone have a document ...
Dnac snow integration for change request
I’m working on integrating ServiceNow (SNOW) with Cisco DNA Center (DNAC) for automation of network changes.For example, when I raise a Change Request (CR) in ServiceNow to configure a new VLAN ID and VLAN name, the goal is that:ServiceNow sends the ...
Cisco STACK-T1-50CM Thumbscrews
I have a customer who is struggling with the Thumbscrews that are used to secure these cables to the routers. I am trying to find out if there is a part number associated with them and if it is possible to purchase replacement screws. Or if the...
Need RV260 Legacy Firmware (1.0.00.15 or 1.0.00.17) to Restore SSH Acc
Hello Cisco team,I have a Cisco RV260 router currently running firmware 1.0.01.10, and this version no longer includes the SSH Local Management feature.For operational and administrative needs, I require access to a legacy firmware version that still...
How to update external phone number mask with same as line
Hello, How to update external phone number mask with same as line on CUCM 14 SU3 with bulk admin ?with bulk admin > Phones > Update Lines > " tehre is external number mask " do we have option to external phone mask same as lines number on multiple se...
Console cable for C1161 router
Hi Guys, Which console can be used on this router? On CCW Cisco suggest this console: CAB-CON-USBRJ45 Below is the console interface
WxCC Live Chat Transcript
Looking to automatically pull or email the live chat transcript once the session is over. Not sure how to configure that in Webex Connect flow.
Resolved! can not access console ISR1100X-4G
when i tried to login to the console port of the ISR 1100X-4g using putty or tera term it shows complicated symbols while using baud rate 115200
Resolved! Rx power low warning in cisco 2960Cx
I am getting below error in cisco 2960cx switch and switch is showing not online.
Upgrading ISE-PIC for FMC
Looking into upgrading an ISE-PIC 3.1 installation to 3.4. There is just the ISE-PIC server pair without a PAN. Is the upgrade process the same as I see for a full ISE upgrade? The documents that I have found indicates that it could take more than...
ISE upgrade 3.3 to 3.4 any problem
anybody have problems upgrading ISE upgrade 3.3 to 3.4 any problem
| User | Helpful Count |
|---|---|
| 65 | |
| 59 | |
| 54 | |
| 52 | |
| 46 |
