TelePresence and Video Infrastructure

does the c20 has MULTISITE capabilities?http://www.tandberg.com/collateral/TANDBERG%20C%20Series%20Solution%20Sheet.pdfIn this PDF it says:Available with MultiwayWhich is not clearI have 4 locations and no MCUI need to understand this.Also can I do M...

on my network .. i have cisco router 2610xm  and  20 ip phone cisco 7960 . i want to connect them to PSTN .i know that i need E1 interface ... but I want to know the type and the reference of card that will work very well with my router .NB : E1 just...

Hi,I have a problem with TEHO and SIPTRUNK.The scenario is an AVAYA using  a SIP Trunk connected to a CME connected to the PSTN over QSIG E1.Calls from the AVAYA to any IP Phone on the CME are working fine.Calls from the IP Phones on the CME to the P...

Hi,I am pretty new in Video and TelePresence part and need the expertise advice.I have two E20 with me for a demo. The running CUCM version 7.1.3 is available.In the demo, I need to demostrate Video call between both the E20 and other IP Phones(audio...

HIi have been tearing my hair out with this im trying to setup a home lab for my CCNP Voice labs and using my 2801 as a skype gateway and cant get the dame thing to work i have been searching and searching and cant find anything to get it working i h...

Dears,I have a Cisco 9971 and a polycomm hdx registered as SIP phones to my CME.Video Calls initiated from Polycom to 9971 works susccessfully and i can see from the polycom side that it is transmitting h264 and receiving h264.but video calls initiat...

I have setup a call center and I would like for the agents to use the DID associcated with incoming calls for the outbound calls. So if an agent makes a call outbound on his/her agent extension, and if the receiving party misses the call, that person...

Hello Everyone.My problem is, that I'm trying the integration of an Cisco TelePresence Manager into our TP network.I read all the information on the cisco website, and did everything, what is writen there, but I get error everywhere.At the CUCM integ...

Hi Guys,we have Cisco IPT in the compnay and a customer wants to make a video conference using Polycom VSX 7000.is it possible since to make a video call from Polycom VSX 7000 to Cisco IPT or vice versa?please it is little urgent......Thanks in advan...

In comparing calls that are traditionally connected using an endpoint's multisite option versus calls that are connected utilizing a Codian MSE 8000, it is noticeable that shared PC content is much clearer and sharper via the traditional means and su...

Can a VCS control make video calls outside the enterprise via CUBE instead of Expressway?  I know that using Expressway would be better, but we are trying to get something up and running quickly with what we currently have, with a view to purchasing ...

H320 to H323 gatewayI  have to set up a video conference environment with a video endpoint registered how h323 to CUCM. Internal videoCalls run ok.I have problems with PSTN videocalls. I route this videoCalls to a Cisco Gateway 2821 by E1.Cisco 2821...