TelePresence and Video Infrastructure

when i use forward call option in an 7961, the extension number enter in busy tone when somebody calls.The scenario is like thisi have an extension (110) when it use the CFWall option to any other extension, when you call (110), it send it back busy ...

HiGood Morning!!!Today i had an issue with my voice network. Its queit strange to me and it is higly appreciated if someone can help me.let me explain my problem. ... It was too delay while reciving PSTN call to my Voice network. But after few minut...

Hello,Does anyone know the most efficient way to configure a crash line on a analog phone, connected thru a vg224 analog gateway?? I know it's possible but I cannot seem to find any literature regarding it online. Maybe I'm not using the correct te...

I am running CUCM, and using an H323 endpoint as a Tandberg 1700 unit.I can make / recieve calls using H263 video, but when selecting H264, no video appears.H263 quality is less than desireable as it appears on the Tandberg. Any advice would be grea...

Hi,I have CCM6.1 + MCU3515 configured for skinny only.I want to have a multipoint videoconference between 3 SCCP video endpoints (7970+VTA).If I try to make an adhoc conference, I only have audio, no video.If I try to initiate the conference from the...

Hello,- We have 4 Tandberg MXP 6000 located at 4 location.- The 4 location are connected at 10 MBits in star model- The central location has a cisco 4503- The 4 locations have cisco 3750Two interfaces of the 3750 are connected like this:interface Fas...

I have integrated a ucm to meridian option 11 via e1 r2-digital r2-compelled on meridian is DTI CARD. the problem is that: when make calls from nortel phones to cisco phones the first digit on ani part is not send to cisco. for example the extension...

Can we do Video Conferencing Using CME or CUCME If Possible give me the link for the documentsThanks,Hari.Sivaj

I have an existing qos policy for our branches and main site. We are implementing video phones in our branches and I have a few questions on how to best implement the qosThe branch config is as follows, currently the voice and data is in the same cla...

Hi,I have 2 X 2960 switches that have 2 trunks (Etherchannel) with each other.For configuring the qos for voice, I have set the following configuration on switch port switchport access vlan 101 switchport mode access mls qos cos 6 mls qos cos overrid...

I am setting up a pilot application and need video to start up automatically when the phone goes of hook on a received call. I see nothing in CM 7 that would allow this.

I'm looking for a Cisco product (or other product) that allows the recording of videoconferences from the Cisco Video Teleconferencing 3545 version 5.Can someone provide me some direction?