Resolved! How do you make phone beep while on hold
Someone requested to have their phone beep every minute when they have someone on hold to remind them they are still on hold. Can this be done? They have a 7960.Thanks.
Someone requested to have their phone beep every minute when they have someone on hold to remind them they are still on hold. Can this be done? They have a 7960.Thanks.
Hi,I have a confusion with the configuration of the MCU in CallManager when i want to have a multipoint videoconference where 3 SCCP viedo endpoints(7985) and 1 Polycom video endpoint (H.323) participate all in the same confenrence!Here is attached t...
This issue is half solved under you suggestion. But I still have issue:Scenario Below: A 3rdparty SIP phone(Xlite) controlled by a CUCM Server, Add a H.323 gateway(named HQ1) to this server, A software phone(CIPC) Controlled by a CUCME(named PSTN), C...
Hello:I want to use a SBC for videoconference over internet between my H323 network and other IP devices. How is the better option?. How the internet users can call me? I must to deploy the SBC in the DMZ? o a GK in the DMZ?What documentation can I r...
Hi,I've posted here some message, but i don't see there.So I retry to send the post :Is it possible to make videotelephony between CCME and a CCM6 ?Actualy, there is two sites. The main Site use a CCM6 and the remot site use a CCME. In each Office al...
I'm trying to do traffic shaping for one of my customer connected thru a VLAN subinterface. the following is the configuration , but as per the SNMP graph the traffic is exceedingthe limit specified by the configuration acess-list 100 permit ip any a...
is it possible to advertise default routes in eigrp
Hello,I want to establish Video Calls between 2 independant IP Telephony network, one with a CUCM 6.1, amd the other one with A Call manager system. I have a Cisco 2811 on the Call Manager side, who have a IP Public adress.The Voice Call is working w...
I have asymmetric Internet, Download 1500 kps and Upload 300 KbpsI can control the upload but i can notthe download.
i configure the MGCP and connect the router to the pbx but when we call from ip phone to the analog phone we can hear anything it vice versa.anyone can help
Hi,Is it possible to do a 3 conferencing (adhoc) using a CUCM6 ?i.e after calling one person, I call another person using the conference adhoc and both will be in conference with me.thks.
I have an Avaya IP phone connected to a Cisco 3560 PoE and the phone will be located in a public location. I believe there is a way to disable the PC port on a Cisco IP phone, but I have been told that Avaya does not support this and it must be achie...
Can you let me know if you can have a mixed mode Video conference i.e H323, SIP and SCCP. I know you can dial into a MCU using a "Meet Me" set up but can a H323, SIP device conference, set up a conference in a SCCP end point and vice versa. A call st...
Hi, allI have found the following dial-peer in several case stadies. It match all called number, but there is not voice port configuration under it. So what is the effort for this dialpeer?---------------------!dial-peer voice 10 pots incoming called...
Would it be possible to display the IP address of an incoming caller on my caller ID?The calls are from 7931s at remote locations to another 7931 on my desk.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
10-10-2024 08:41 PM | ||
10-06-2024 09:05 AM | ||
10-04-2024 06:18 AM | ||
10-02-2024 07:36 PM | ||
10-02-2024 06:18 PM |