TelePresence and Video Infrastructure

Hi,I've got a centralized deployment with CCM6 and two sites. I used two H.323 gateways and set the PSTN access code to 9. I defined my route pattern and put my gateways in a route list. My problem is that I've got most of the calls from site B route...

Hi,I've got a centralized deployment with CCM6 and two sites. I used two H.323 gateways and set the PSTN access code to 9. I defined my route pattern and put my gateways in a route list. My problem is that I've got most of the calls from site B route...

what is the best method (s) to get voice quality and performace reports on a CUCM 6.X Cluster.

I am running CUCM 6.1.2 & IP telephony with firmware 8.0(8) in the network .After setting up CUVA 2.1.2.0 in PC ( XP SP2) ,I observed the following issue.Meanwhile, video Capability & PC port enabled in each 7940 phone device in CUCM 6.1.2 PC system ...

Hi everybody,I have problem with my network module CUE. I changed its ip address few times and I always use those commands :#interface service-engine 1/0# ip unnumbered fastEthernet 0/0#service-module ip address ip_adrress#service-module ip default-g...

Hi to all, we have a IPTV problem.Our infrastructure is this:-1 DMM 5.0-10 DMP4400-1 GALAXY Scientific Atlanta with terrestrial and satellite receiver-1 DCMd9900 encoder Scientific AtlantaWe have no problem about rx signal, because we try with VLC o...

I have deployed CUPS 7.0.3.10000-63 and am encountering a problem when adding CUPC as a soft phone. Our userIDs consist of our firstname.lastname, for example, joe.dirt, but it seems that "." is an invalid character. Is this true and if so is there...

Hi everyone, I'm basically newbie here and can't get the VMSS module to work in a 2811.I've been reading this links with no luckhttp://www.cisco.com/en/US/docs/video/cvmss/rel1_1/installation/guide/cvmssinst.html http://www.cisco.com/en/US/docs/video...

Dear all ,I use config tools CISCO2811-V/K9,when I choose CME have only FL-CCME-35.I have question FL-CCME-36 EoS?

How can I integrate a InterTel PBX to do 4 digit dialing with CM?

I am trying to set up a qos policy for CUVA and I am having trouble getting a clear andser on these questions:When the video call is established, are the endpoints the PC IP Address, or is the the phone IP Address?I want to isolate the video and voic...

Hello,I have DMM Version 5.0.2. When I trie the feature Play in Future under the Schedule Tab I can not see the calender.I use a German WIN-XP-Prof, SP3, Java Version 1.6.0. Any idea?

Quick question. Do the new Cisco Displays have the DMP's integrated or do I still

Im having some little problem anybody have idear on it,the problem is i have site to site connetion and i connected ericsson pbx md110 to each site,but when im calling from each site the calling does not appear on it unless the person pick the phone ...