TelePresence and Video Infrastructure

Dear all,I just configured a voice gatekeeper with 7 nodes of voice gateway,when I configured the 5th gateway, show gatekeeper end-points, the 5th gateway is not attached to gateway even to 6th & 7th.May I know that one of gatekeeper, what is max no....

The customer is goint to setup Polycom between 2 offices. With the limited budget, can I setup one 2610 working as both Gatekeeper and Gateway for each site?If yes, which IOS is recommended? Please provide a link for sample configuration.If no, which...

1510 router sees FXO in slot 2 but the ports do not show up in theconfiguration.

Hi,I have a Voice gateway terminating 2 voice lines( T1-PRI).On this gate way I have two ethernets.Is it possible to send all the incomming calls from one T1 out of one ethernet and all the calls form another T1 over other ethernet?i.e mapping the T1...

Hello!In this file(admin.prf) i can modify the IP adresses, so i can acces the Content Manager as an admin. BUT, how can i give more IP adresses?I read about this(with AND), but it dosen't work.Can you show me an example?thx

We are using the PA-VXB-2TE1+ board in two 7206 routers that are connected together with 100mb afstethernet. PBXs are plugged into the PA slots and we are using the 100mb FE to transport VOIP packets along with normal data IP traffic. What is the b...

I got a repeated faulty about the port defected on a VIC-2FXO module, and I suspect the symptom causes by enviornments. Is that any tools can use for tapping the extension line for mointoring the voltate/Current status, or any debug command at Cisco...

I have created a LLQ policy on a 1721 running 12.2(4)YH2 but the counters do not incrementing. I disabled fast-swithcing and the counters increment. Is this correct and is LLQ being used even though the counters do not show the packets being matche...

Hi,Please let me know what IOS version is cable of acting both as voip gateway and gatekeeper same time for 2600 and 3660 plaforms.Best regards,Kassa

Are you aware of any problems with the loading of 3.3(2), we have anew call manager which has been loaded as a new installation and fails every time to load Cisco Directory. The load just freezes and has to be manually shut down. We ha...

We are planning to establish a network in our organization, which has 20 branches all over our countery. We'd like to have voice over frame relay and later, Video conferencing. Of course data will be transferred over the network.I know that vanguar...

Hi All,I am learning VoIP now and I have serveral questions:1. when I use "destination-pattern" command in "dial-peer" command, how will the number forwarded? For example: If I want to forward the number 123456 to ip x.x.x.x. If I use "destination-pa...

Hi,I'd like to know that the call manager and gatekeeper is the same or not.If they are not, can anybody explain some of their differences in brief ??Thanks.regards,Moe

Hi,I have connected Erricsson MD110 with E1PRI card and Cisco 3660 with NM-HDV-1E1-30=,Single-Port 30 Channel E1 Voice/Fax Network Module using Qsig.The problem is that out of 30 channels only 15 are working (1-15). Both PBX and 3660 shows all chann...

Hi,Could two VoIP gateways (AS5300) with 2 different DSP (C542 and C549) work without any problem? (With the same codec)I heard that it is recommanded to use the same DSP technology and software version but no direct mention in Cisco site.Thanks for ...