HiI have project where I would like to use the SX20 codec, due to it being having multisite at an affordable price. But locating the codec and camera together is not an option for this installation. So I need to extend the camera cable,Picture attach...
Hello friends,my first question is : 1. Is there any kind of software that i can install on a laptop so that the laptop can connect to a VCS and use it as an Endpoint?My second question is :2. How many people can join a few conferences at the same ti...
And the next question:Is there a guide that describes howto push SIP Outbound configuration to users?We deployed subsequently a VCS cluster and a lot of our users have only one VCS configured.ThanksJuergen
Hi all,I have a Edge 95MXP with multisite option for 4 sites conference via Internet (not WAN). Now I want to use Jabber Video. As I know, VCS-C and VCS-E are required. But my scenario is a little different from deployment guide: internal network is ...
Hello,When booking a conference, is there a product that can verify that the video bandwidth is not going to be exceeded at the time of the meeting and prevent overbooking?Is there product that can drop adhoc video calls to audio when conference call...
I am getting an error in my configuration template for an MX 300 that I'm running TC6.3 on. The only output I get in the Configuration Templates Activity for it is: A template value was rejected by unit name. Location: /Configuration[1]/Reason[1]Any...
We have connected the ISDN Link with the C series codec. The codec IP is NAT to the public IP, the codec is not receiving the far end video and there no Rx on the codec. Even the port open for any/any still the same result. Is this beacause of the IS...
I'm using an EX60 attempting to dial a h323 device. If I dial from the dialpad H323:<IP address> it connectes fine. When I save this number in the favorites and dial by pressing the favorite it says unknown address could not place call...On the favor...
We are having a few issues here with Call Manager 5.1 whereas the phones have started to reboot randomly, they have been fine for over 18months and to the best of my knowleagde nothing has changed on the network, below are the debug logs taken from t...
Hello ,I read in the admin guide for the conductor the followings:" The TelePresence Conductor supports the most basic MIB-II tree (.1.3.6.1.2.1) as defined in "RFC 1213.The information made available by the TelePresence Conductor i...
We have a multi-point call each week with 8 Cisco EX90 endpoints and a MCU 5320. The devices are registered to VCS and managed in TMS. During the weekly call, the same endpoint will get disconnected during the call, then the system will reconnect, ...
I am running TMS version 13.2.1 and I can bring up conferences/schedule them fine but when I try to view a snapshot of the conference or try to change the layout of the screen it freezes up then does not respond. Also, I'm running Java 6 update 33...
Hey guysfrom all the documentation that I can see as you are not able to set softkey templates on the 9951 all the video ones should prompt automatically when a phone call is activated.We have a CUCM with 7.1(5) running which supports the video capab...
Hello,We are in the middle of rolling out VCS-C/E, TMS and MCU and we are wondering if we might be able to get video between calls on our existing 7975 phones. I was under the impression that the Jabber client would be able to handle such interactio...
