TelePresence and Video Infrastructure

I am currently running an instance of TMS 12.6 and attempting to pull in Active Directory user info, specifically the ipPhone field.  We have phonebooks separated into folders, ABC, DEF, GHI etc going by last name.  I created the AD Phone Book Source...

Hi all,We run many VCS Controls that peer to single VCS Expressway. All devices in the group run x7.1 at this moment in time, however, we need to swap out a VCS control for a new device. The likelihood is that the new device will have x7.2.2 from the...

I have having an issue with an outside organization making an H.323 call to us.  We are an all SIP house.  I have my VCS Express set to translate the call to SIP from H.323 and when the distant end calls I can see them connect for a short time.  This...

Hi,please help me i have installed my cisco SX-20 device but there is a problem with when i goes to control threw crestron AV2 processor there is nothing happen with control.Requsted to help me to share the exject module for SX-20 for ethernet contro...

Hi all,i need some help...I have a file based phonebook, which is just an Export of a Manual phonebook...in the manage phone book source pages, i set it up, i click on view contatact tab, and there they all in all their gloryi then create a NEW phone...

Dear Experts,how can I make a dial-rule for calls to VCS from CUCM? I mean, I can make a SIP Route Pattern with cisco.com or *.com butI would need a wildcard for all pattern. I tried to use *.* but this doesn´t work.Do you have any pattern which is w...

Hi Guys,I normally deploy VCS-C and VCS-E but never a VCS Starter Pack.  I have a question about phone books.  If I had Movi/Jabber users on the VCS Starter Pack and End Points managed by TMS, how can I make one simple phone book so everyone can see ...

Hi Everyone,I have an issue with one of the MCU ( 4510), at our customer place, where it is automatically rebotting in every 30 seconds, i have checked the Health of the MCU and it is good.but i can see its running on very old version, but because th...

                   This is on a Tandberg 3000 MXP Profile. problem is for sure related to getting the correct settings into the router but no one here seems to know what happened to the manual. The  unit is about 4  or 5 years old but seldom used.We ...

I am working with a group that has SX20's behind 2900's using IOS firewall (but we have opened up the firewall to traffic) all registered to a central CUCM.  When these endpoints dial out to an independent H.323 endpoint we are getting one-way audio ...

We have 13 sites and (2) CCM clusters.Each site is either 4 digit, 5 digit or 6 digit extensions, with some overlap between the 2 clusters.This overlap forces me to prefix digits when dialing between clusters.I have a project to switch to 6-digit dia...

Hello everybody,If you have a hardware conference bridge, does it make any problem to turn off the "IP Voice Media Streaming App" service? If I am not wrong, if you turn this service off, software conference bridge stops working. Thanks,Fatih.

Hi,I am deploying a setup per the following design referenced in this document:http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/Cisco_VCS_Basic_Configuration_Cisco_VCS_Control_with_Cisco_VCS_Expressway_Deployment_Guide_X7-...