Hello,I understand it is possible to create a SIP TLS/IpSec trunk between CUCM and VCS without using a certificate from external CA.For this the CUCM must be in mixed mode. But how to import the VCS certificate into the CUCM or do ...
We have three Cisco C40's on site set up identically and I am having an issue with only one of them. The issues is in the Call Control portion of the web interface. I can control the primary camera just fine, but if I switch to the secondary camera, ...
I have a customer that is currently migrating an old environment of codecs just thrown out on the network and then had NATed a public IP to the device's private IP for connectivity to the internet. this is not an uncommon deployment, but we are now ...
Hi All,TMS v 14.2, TMSPE v1, VCS 7.1]I have some schemas and templates installed on TMS for the provisioning of information to Jabber Video and old Movi clients (going back to version 3). I have been able to set up the provisioning template on one ve...
hi everyone,I am new on telepresence, my client only purchase the MCU and two P42C40 and don't purchase the VCSc and VCSe, so the P42C40 are registered on CUCM version 8.6.2 as phone. So I create SIP Trunk on CUCM and route pattern for communication ...
Can anyone confirm that the Lync-VCS integration using Trusted Application and a Static route does not support Polycom VSX/HDX devices?Calls from Polycom (registered to the VCS) to Lync work, but calls from Lync to Polycom have one-way media (Lync to...
To whoever can assist.We currently installed an SX20 system in 2 of our offices, Head office and a branch office. We currently have a WAN connection between the 2 offices with a 20MB connection between the two sites. Our branch office has about 30 fe...
Hi,One of our client has installed C40 device,three month back and it was working fine.today they just did the factory reset unknowingly, after that we are not able to reister the IP Addrees in the device, while entering the remote Ip Settings are sh...
We started having issues with this unit a couple of months back. After 10 minutes or so of use, the unit would quit working and there would be a constant rapid click in synchronization with the red and green light flashing, likely a relay. Initially ...
Hello,We have encountered a problem with TMS booking. We are currently running 13.2.2 and endpoints are on 6.1, but we have tested this with multiple versions of 5.0 as well. The problem is that when booking a call between endpoints (No MCU) that i...
Hello,As we have moved to the latest version of Cisco Jabber Video and within the next 6 months all employees will be off Movi and onto Cisco Jabber Video, we are looking into changing the .movi to .Jabber. I am having a hard time finding how to do ...
HiWondering if anyone can assist with an issue, Have an inbound call whch is routed to a 3rd party IVR over a SIP trunk.The call is routed to the IVR OK, except DTMF tones are not received/processed by this systemRegardsDavid
Prior to 14.2 the Last Used participants could be configured, whereas this was removed in 14.2 and locked to a maximum of 10. This is clearly mentioned in the release notes, however, I really do not understand the thinking behind this.It has become a...
Hi Everyone,we are facing 1 peculiar issue from one of our mxp series endpoint, where the call gets disconnects in the between the call, we are calling from our local endpoint in india to an another mxp endpoint in UK over an dedicated IP link.Both...
Is it possible for the Touch Panel to remember username and password for pairing after codec or touch panel is restarted? As we were testing the system sometimes touch panel was able to pair without typing username/password, some other time it was no...
