TelePresence and Video Infrastructure

Hi  Because of the first time i might use EX60, but i do not know about it. so i have a question, can I make a connecting from EX60 screen to PDP TV or a project. and i need some detail information about EX series.Thanks

All,We are seeing a problem where if a C40 brings (2) MXP endpoints into an MS call the MXPs will have a huge black border around them in their own little window on the C series.  I have included detailed directions below on how to re-create this iss...

Hi you all!I have this scenario here:01 C4002 PrecisionHDOne of the PrecisionHD are 20m away from the C40 codec, and the other is 40m.Regarding the HDMI video signal, I'll convert it into UTP cables to extend the distance (no problem).Regarding the c...

Hi, I am currently setting up a CTS3010.  When I connect the VGA and Audio cable to my laptop, the display is fine.  However the audio is only coming out from the Center Left Speaker.   I would like to know if the audio should come out from both the ...

Hello Cisco Community,I have a customer with several sites, where is still one Polycom ESX7000 or Viewstation ESX System at these sites.For the central site, a CUCM 8.5 will be installed with Remote 29xx SRST Gateways at the remote sites. My problem ...

All the support docs I am downloading on Telepresence Management Suite refer to version 13.0, but the download is 12.6.Where can i find 13.0?Andy

HI,i've ex90 endpoints and trying configure them with SIP but call from SIP to SIP endpoint isn't working while call from SIP to H.323 is working. pls advise how do i fix itthanks in advance.

Hi,1) which DSCP marking to use for ex90s?2) as a test we are planning do to deploy ex90 at few of locations. at location 1 we will do DSCP EF marking while at the other location we will do DSCP AF41 for video.LOC1--(DSCP EF)----------------(WAN clou...

does the c20 has MULTISITE capabilities?http://www.tandberg.com/collateral/TANDBERG%20C%20Series%20Solution%20Sheet.pdfIn this PDF it says:Available with MultiwayWhich is not clearI have 4 locations and no MCUI need to understand this.Also can I do M...

on my network .. i have cisco router 2610xm  and  20 ip phone cisco 7960 . i want to connect them to PSTN .i know that i need E1 interface ... but I want to know the type and the reference of card that will work very well with my router .NB : E1 just...

Hi,I have a problem with TEHO and SIPTRUNK.The scenario is an AVAYA using  a SIP Trunk connected to a CME connected to the PSTN over QSIG E1.Calls from the AVAYA to any IP Phone on the CME are working fine.Calls from the IP Phones on the CME to the P...

Hi,I am pretty new in Video and TelePresence part and need the expertise advice.I have two E20 with me for a demo. The running CUCM version 7.1.3 is available.In the demo, I need to demostrate Video call between both the E20 and other IP Phones(audio...

HIi have been tearing my hair out with this im trying to setup a home lab for my CCNP Voice labs and using my 2801 as a skype gateway and cant get the dame thing to work i have been searching and searching and cant find anything to get it working i h...