Voice Systems and Accessories - Small Business

                   Hi, I'm looking to invest in a BE6000 but wanted to get something clear beofre I take the leap, Is there anything else I would need besides the BE6000, POE switches, IP Phones and SIP Trunk proivder? Out main routing device is a So...

Using CCA and  I’m trying to upgrade US540’s software. After the first stage, I’ve this message: Ping researchable test failed from CUE to CCA embedded TFTP server 192.168.0.78 please check ….The message say  that the TFTP server is on IP 192.168.0.7...

Does the UC540 provide functionality for dial-in conferencing using an 800 number? If anyone could point me in the direction of any documentation that outlines the UC540's conferencing capabilities in general, I would really appreciate it.

So I have a VPN setup on a customers UC560 that has been working just fine for close to a year.  The 525 phone worked well at a remote location for 6 months and has been nothing but problems since.I have wiped it to factory defaults, updated the firm...

I've configured a HTTP provisioning server and have set up a Cisco ASA to send out the address via DHCP. Currently this setup works for the SPA504Gs which will get the address and provision correctly. The SPA941s however won't co-operate. They don't ...

Hi Guys,We do have Cisco SPA 525g2 configured with 3 extensions. Line 1 works perfectly just fine (no issue at all). But with the use of the OTHER LINES, i can't seem to make it work. Registrations seems to be fine, audio works for a few times at fir...

Hi everyone,1) I've login into the webUI of SPA3102 but can't find any Admin option at the right upper conner. 2) I've trying to upgrade the firmware but hold for 2 hr on below status.            Please kindly help.Thanks and best regards,Eddie

1. Is there any way or parameter setting to speed up call routing to PSTN line ? When number is dialed on phone connected to FXS and routed via FXO there more then 5 seconds need to receive ring-back from outside public PBX. We tried  adjust Interdig...

Hi,I set up voicemail for uc540, and I did receive email notification with attached voicemail wav file. But when I open the file and cannot hear any voice.I cannot hear from my SPA504G phoneset either. Any idea would be very much appreciated.

One of our SPA525G phones is no longer working. There is no ringtone and the lights are not lit up on the 2 phone lines???

Hi All,We have a UC560 and would like the phones to ring then after a specific number of rings, the phone would go on silent mode but still would flash when the call is still unanswered.Is this possible on the UC560?

HiI have a UC-560 and I want to send automaticaly the CDR for all outgoing call to the FTP serverI it possible to configure this feature on uc-560If yes how can I configure it ?sh versionCisco IOS Software, UC500 Software (UC500-ADVIPSERVICESK9-M), V...

I have configured two of the FXS ports on our UC560, to act as analog ports for fax machines.   Each FXS port has been configured with an extension from our publicly routable DID range, and the ports are configured for Loop Start.However, I am not ge...