Voice Systems and Accessories - Small Business

Has anyone been successful in programming babytel sip trunks on the UC320?

We’ve just implemented a UC320 and find that sometimes it reboots all the phones.The firmware version is 2.1.4 (3)The reboots are happen outside to the Auto Maintenance  time.

Hey is anyone aware of different SPA phone stand other then what comes with the phone already.  I have a cleint that does not like the angle of the stand that the 509G come with and was looking fo rsomething else.  Let me know if anyone has run acros...

I have SPS525G2 phone with fw 7.4.9c, connected to SIP provider and have the same problem, like described in https://supportforums.cisco.com/message/3171421#3171421 with little difference:Phone does not search and display incoming caller name by phon...

Hi Guys,I am installing UC320W for my end customer tomorrow. They currently have ADSL2+ service for there data; my plan is to use UC320W as PPoE. I need some help in deciding which cisco router I should buy to replace there existing ASDL router? As I...

I am running a network of 16 users. Each user has either a SPA504G or a SPA 509G and are all connected to a UC540. Users would like to be able to add their own personal directory entries on their phone but we are not able to find a place to do this. ...

I have struggled with an issue where our number reports itself as busy when people are trying to call us. But the phone is not in use. First I thought it was an issue with the VOIP-provider, but they says our equipment is reporting itself as busy. Th...

I am having a problem with single number reach not pulling the call back to voicemail.Basicly I call the extension and it does go to the desk phone and calls out to the cell phone. The problem is after 15 seconds its not sending it to the extension f...

I am interested in using the UC-320 as a sattelite system off an existing PBX but due to the fixed dial plan I can't dial the PBX outdial prefix as the dial plan won't allow it. Does anyone know of a way around this or are there plans to allow a "Beh...

Hi,I have a UC320 which has been up and running for a few months now. I have a SIP trunk from Gradwell which works by a static IP address and doesn't need registration. It's been working for a while before I updated to 2.1.1At first I though this was...

please help with this problem.....UC560#service-module integrated-Service-Engine 0/0 statusService Module is Cisco Integrated-Service-Engine0/0Service Module supports session via TTY line 2Service Module is failedService Module heartbeat-reset is ena...

Hi:following UC320w instructions I updated firmware to V2.1.4(3). Te update went throughg just fine but when I tried to relog into the system it kept telling me that user and/or password was not correct.I reset system to factory defoults and went thr...