Voice Systems and Accessories - Small Business

Hi,We are expierencing problems with FXO lines. We have all 4 analog lines connected. But when someone makes a call to outbound then the system automatically selects FXO 1 or 2 line. I need to make a solution that when a call from phone is made than ...

I have a number of 504G with sidecars on a UC540. Each phone is setup with a button of the other phones to transfer calls or make internal calls. When a user presses a button, we'd like to have the recipients phone auto answer in intercom with speake...

I finally have the Smart Call Connector Advanced installed and working on my Windows XP SP3 x86 PC.I have a line of business application (Connectwise) that has a Tapi click to dial capability.Can Tapi enabled apps peacfully coexisit with SCCA?If so, ...

I have a few SPA504G's with 1 SPA500S sidecar attached. None of the buttons work or light up. I'm not sure it even has power. I don't see any settings on the phone to configure the side car and nothing in the web interface of the phone. http://www.ci...

Does anyone have the right combination of settings on the SPA  (50x) phones to get a N-Way conference call to work with Broadsoft.  I have the conference URL set in the "Ext 1", Supplementary Services - Conference Serv = yes, Conference Package = yes...

Hi,I have been contracted to setup a small network with a voice system for a small business. I am thinking about using a UC320 for voice and Wi-Fi, SG200-26P as a PoE switch, and SA520 as an Internet firewall and a VPN headend for remote users. Are t...

I was trying to figure out where to post this, but couldn't find anywhere else...In the latest f/w update (7.4.9) on my SPA525G2s, they addressed an issue where if you have the clock loaded on screen as the screen saver - and you press a digit to sta...

When making an outbound call there is about a 5-6 second delay before you hear ringback when calling outbound via FXOCalled SBSC and they said they have to escalate to development.Any recommendations to remove this delay?Running the latest firmware o...

Hi, I recently buy a SPA8000 and I've got problem to register lines from 3 to 8, I noticed that the only difference with the lines 1-2 is the NAT MAPPING ENABLE, the lines 1-2 are set to NO but the other lines are set to YES without the possibility t...

Hi, I am trying to update my firmware but I can only download v2 firmware but I need v1 firmware. Is there a way?Thank you, Christoph

Hi all,I have a site with main office and 2 users at a remote site connected by a high speed wan. I would like to add a couple of phones there and get them to connect to the UC320. Does anyone know if this is possible? Without trying I'm not sure how...

Hello Everyone,I have the the following Cisco products: - Cisco SPA9000 (IP Telephony System)- Cisco SPA8800 (Gateway)- Cisco SPA 504G (4-Line Phone)- Cisco SPA 303 (3-Line Phone)They are all properly connected to the network and can reached through...

Trying to integrate UC560 (no wireless) with customer existing TrendNet TEW-637AP.Setup (7925G)----->wireless------->(TEW-627AP)-------------->LAN------->UC560.The 7925G will be on a different IP subnet than the Voice VLan for the UC560.In reading CM...