Voice Systems and Accessories - Small Business

Hi all and thanks for reading,I am assigning speed dials to SPA500s attendant console. I am using a script like the one below.fnc=sd;JoeSmith@10.1.1.10;ext=0043xxxxxxx@10.1.1.10;nme=JoeSmithAs you can see the only function programmed is sd but the li...

I have a uc540 with 7 spa phones.I initially deployed the uc540 with the software that came with it. Which was 7.0x and that was approx 2 months ago. Everything worked well, but I thought I should upgrade to version 8.1 before the end users start usi...

i am not able to regeister my spa502g phone withspa9000.the spa9000 is already configured with basic configuration also the spa400 is attached with it.but when i try to configure client stations, the phones mac address doesnot shows up in the drop do...

We are relatively new to Cisco - I have seen the term ephone serveral times,what does ephone mean?

I have 3 different sites with AT&T DSL that I cannot get to work with the UC540 setup as PPPoE.  It is very frustrating.  I have 2 different SBSC cases open with no real results.  I tried using a bridge modem and a Netopia 3546 router.  The Netopia w...

Hi,I have deployed an UC500 and my question is about how to recover automatically an already transfered call to the previous extension. For example, an operator transfer a call to a sales person, but the call is not anwered after X seconds, then the ...

I have a working 7965 VPN phone via an ASA5505 and 2811 CME router.  I would like to do 2 things.1) Have the VPN Phone authentication via certificates. I don't want to enter a username and password everytime the phone powers up, I just want it to con...

I have installed a UC560 about 2 months ago for one of our customers who is a Travel and Tourism office.  The customer went from Analog lines on the old phone system, to a PRI with the UC560.   They are using the SPA508 phones, and the UC560 has ver ...

I have a PAP2T and need to configure this to connect an doorphone (like an intercom).But i got a problem with some settings that are not available in the configuration of the PAP2T.FXS port Impedance: CRT21 <- This is the setting that i have to make....

guys,is there a possibility or is even doable to setup multiple b-acd on a single unit? i tried to setup multiple b-acds through cca 3.0, but it's not working. the cca allows me to configure the pilot and all b-acd parameters, but it's not doing its ...

I have implemented the TimeCardView, which works great, and I enabled the Phone-call Interface for it. But I cannot seem to find out how to use the TimeCard applicaiton via the Phone-call Interface. Does anyone know how this works? Thanks in advance!

I have setup a SPA400 with 4 FXO lines. When I receive a call via FXO port and the call is not answered, then at the next call  that I receive via FXO port , I see the caller id of the previous unanswered call. Is this a bug or I have to setup someth...

Hello,I am using CCA 3.0 with UC520 and cannot transfer call to a user with analog FXS port.The call simply ends up in voicemail after many rings.The actual phone works and can even make call during the actual process.What can be done?Is the a config...