Voice Systems and Accessories - Small Business

We've purchased CISCO phones 7960 with SIP firmware to work with Asterisk PBX. Later we decided not to use Asteriks and purchased CISCO UC 540 instead. But it turned out that the phones cannot register at CISCO UC 504. What can be done in this situat...

While trying to debug anotherSPA525g issue, I decided to take a look at the *.cfn.xml to see exactly what was being delivered to the phone.I was under the impression, mayb wrongly so, that I could just tftp to the UC500 and request the *.cfn.xml file...

I've set up a B-ACD que with one member, when the hunt timeout ends the "All agents busy" prompt plays and then the call disconnects. I would like it to continue to hunt on the member until the phone is picked up. Have I missed something in the confi...

Hi,I just wanted to get feedback from people who have large installs 50 -100 phones with a UC 5x0 system. I wanted to know any lessons leanred, challenges, or things you would have done differently; including going to a CUCME instead.I wold also like...

Hi,I have two park slots, 4 conference and liverecord activated; I see that there are ephone-dn from 290 to 300 used for this but now I would like to add another park slot... if I do lose the live record, and vice versa!I look at UC configuration and...

In the example below can I apply one main # to follow this path? So all calls coming into 555 555-1000 would ring button 1, then they would softkey to get to the 2nd and 3rd call on button one, then the call goes to button 2 etc?> Overlaid Ephone-dns...

Hi,I have an UC540 with software pack 8.0.4 (also tested with 8.0.2 --> same result).I have two 7971G iphones, one 7975 and one 7925G. I have configured 3 different extensions on the desk phones 211, 212 and 213. The 7925 wireless phone share the sam...

Hi All,I have a customer who is using a Hybrix GSM Gateway on the UC540. The issue is when calls are routed through the gateway audio is very low and the called and calling party can barely be heard.When calls are routed via the BRI interface audio i...

Hi,I have 0 as acces code for my spanish dial plan. I need an extension to be able to place calls without dialing 0, is it possible?. This extension is connected to a credit card reader, which I have no access to the configuration menu. Before instal...

When is the version (2.0?) of the Call Connector For Microsoft Windows going to be released? Also will it include 64 bit support, and or Mac support on the client side. 

Hi All,I have a customer who is complaining that when he answers his mobile phone his desk phone continues to ring when configured for SNR. After referring to lab 26 of the technical enablement labs I noticed snr 201 delay 5 timeout 30 cfwd-noan 400....