I have a small configuration with SPA9000, SPA400, 2xSPA921 and 1xSPA941 with both the FXS ports used for analogue handsets.The system works mostly OK, but I have a strange "feature" that will not ring the FXS ports when my mother in law phones (call...
Has anyone had experience with an issue similar to this:We recently installed a new UC560 system with 2 of the ESW switches, 8 of the 541 access points, around 30 of the 525G phones, 1 7965, and 20 7925 wireless phones. The issue is with the voice q...
This question came up in our Facebook Community.TimeCardViewer on SPA504G. Does anyone knows how to make it work??!? It's working fine on an 7960, but it does not show up on the SPA405G.
Hello, I'm receiveing the following error on my SPA508G Phone screen: _______________________ S.O.S PhoneInRecoveryMode _______________________ There aren't any blinking lights. Just 3 solid lights: Mic light = red / Headphone light = g...
What is the maximum number of IP Communicators you can use with the UC500? How many free IP Communicator licenses do you get with the UC500?Thanks to anyone that can help.
Dear Cisco UC500 team. Please can you create an XML template for VoIP.co.uk SIP trunks via our private access network and our Private SBC's?1. Please ensure that ephone-dn's, hunt groups etc have "no reg both" to avoid unnecessary SIP registrati...
Dear Cisco UC500 team. Please can you create an XML template for VoIP.co.uk SIP trunks via the Public Internet and our Public SBC's?1. Please ensure that ephone-dn's, hunt groups etc have "no reg both" to avoid unnecessary SIP registration noise.2....
We have a Cisco UC520 Telephone system.When a call is forwarded from the IP telephone in the office to my mobile phone, the number of the office is displayed on my mobile phone.I´d like to ask if it´s possible to configure the Ciscosystem, so that th...
Greetings All,Under the SPA500 phones document within the cisco website it shows that the wallmount kit for the SPA500 series is the MB100. Upon recieving these brackets I found that when the phone is wallmounted and the handle is in the cradle it f...
The answer is this: This product pair is apparently past it's End-Of-Life. My reasoning is that there has not been a new firmware release for about 1.5 years.Why do I care? Because it's time to give up with this product and this forum, and move on ...
The customer has AT&T POTS lines. The caller-id shows as anonymous caller for every incoming call. The phone system we replaced displayed caller-id.The UC540 is on the 8.0.2 software pack.This happened with another customer of ours that had One Com...
There is a link on this page https://cisco-support.hosted.jivesoftware.com/docs/DOC-9794 Called 10 digit local dial config guide. It is unreachable and seems to be the only place where I might find what the matter is with my Call Connector Server. An...
hello we have a uc560 and 2 esw switches, poe, 24 ports each.the uc560 was upgraded to the latest version. we are using cca 2.2.4these are our problemsSome of the 525g's are giving the error "Max number of phones registered" this requires several unp...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
