VPN

I have two remote sites that connect to eachother via ipsec vpn. The tunnel between these two sites appears to be stable... pings/data move freely back and forth. However, opening share folders using the host name does not work while opening the sa...

Hi, I have a dynamic crypto map, which is applied to a Fastethernet interface - in this case everything is OK: I can connect and reach the cororate LAN. But when I apply this dynamic crypto map to a loopback interface using /32 IP vpn client connec...

If I dont want VPN users from using the Company bandwidth for Internet browsing, do I enable or disable splittunnels ?

Hello there,I am a newbie for Cisco VPN solution. I understood that Cisco usually uses GRE over IPSec. Why does it choose GRE for tunneling? Why doesn?t it use another tunneling protocols such L2TP like a MS?Please advice.Thanks in advance,Nitass

Here is the PIX setup with internal addresses:(MAIN PIX 501) <--vpn--> (REMOTE PIX 501)192.168.0.254/24 192.168.2.254/24Using Windows VPN Client, connect to MAIN PIX via PPTP. Need to have access to web services on REMOTE PIX network, but co...

HiI've already seen several posts about simsilar problem, ISAKMP fails on Phase 2 apparently.Most suggestions were about ISAKMP parameters matching on both sidesI was using Cisco VPN client 4.8 and PIX 7.1.1 for RA VPN,everything worked fine for diff...

I am able to configure a 2 factor authentication group with No issues. But is there a way to get the 2 Factor group to work with VPN SSL? Maybe im blind but I cannot find the appropiate doc on cisco.com Any pointers would be excellent.

Hello!We have a c3640 with 2 NM-30DM=s. There was a lot of errors today. When somebody tried to dialin, after a successfull connect speedshifting started and the line dropped after it. (session timeout 60?)Modem 2/7 Mica: in modem state CALL_SETUPSep...

Hi there, I'm trying to figure out the way to replace alias command on ASA.The issue is I have an internal DNS and Webserver. When I connect to ASA via VPN Client, I query DNS and get public IP, but VPN clients can't reach the web server bec...

Hello all,Can anyone tell me what the commands are to enable ipsec passthrough on the 806 router?ThanksDan

I have an Astaro 220 firewall that has to vpn tunnels created, one to a Cisco 1720 and the other to a Cisco 1711 router. The setup in the Cisco's are basically the same as far as the VPN's are concerned. The problem is that I can ping every device o...

Hi.Is it possible to install TrendMicro officescan client in a laptop using the WebVPN service at home? Using Port forwarding maybe? One person claimed that couldn't do it from home. It is given a timeout error.Thanks in advanceRamada