Wireless

I have discovered a serious problem with 1142 APs after moving them to a newer controller version. They were previously ether on WISM or 3750G controllers running 7.0.240.0 or similar. I have moved them to either 2504 or 5520 controller running 8.3.1...

Does any know where i can find the Cisco WLC 5520 Visio stencil? Or does anyone even know if there is one.  If not, then what is currently being used to represent the WLC 5520

hi all i have a question anyone can deploy VWLC Cisco prime or CMX on vcloud. i try to deploy files OVA but not lucky.

Hi,    The IT service installed two new Wi-Fi routers within our company (Cisco Aironet 1830). They completely set it up and I should now manage it. However, we are having difficulties with some iPhones that simply can't connect to the network. iPhon...

is it the correct practise to set the wlc and the ap in the same vlan? in my previous implementations i noticed that when i set the ap and the wlc in the same vlan they wont see each other? i usually separate the ap in a different vlan and set the dh...

I have a situation with Cisco WLC 4402. I have 2 WLAN networks. Corporate network is in vlan188 and guest network is in vlan192. Management interface is on untagged vlan. I would want the controller to be accessible via corporate network but not the ...

Hi Folks, Latest project is to migrate 160 APs from existing 5508s running as primary and secondary.  The existing code is version 8.0.x.  Client want to install a pair of new 5520s configured in high availability mode, not just primary and secondary...

Hi We currently have a guest network setup with internal Foreign Controller tunneling guest traffic into DMZ to Anchor Controller, is it possible to set up another guest SSID and use another Anchor controller but still tunnel Guest traffic for new SS...

Hi All Today you have high density access points, what defines them as high density?  We have Meraki MR42 / MR52 etc, there is a hard limit of 120 clients on 1 access point, how many clients do they recommend today before the quality starts to degrad...

Hi,   1600 series AP's in autonomous mode.  I have 2 SSID's: 'corp' and 'guest' both in separate vlan's with 802.1q sub-interfaces. Corp uses radius and guest uses a PSK, and access is restricted to internet only from the guest.  this set up works fi...

i have ( 4404 wireless lan controller) and i lost my data about the management ip and vlan. i want to reset the controller to default factory, unfortunately i don't have a console cable to log into the controller and reset it. can i hard reset it in ...