Hi, I have Cisco WLAN Setup with following details WLC: 7.4.130.0 WCS: 7.0.172.0 MSE: 7.0.105.0 Context Aware Service : 7.0.105.0 wIPS Service: 1.0.2066.0 The issue is that i am not able to track rogue access points via WCS. The snapshot of WCS is ...
Forum Posts
Dear all, I am performing an estimate on CCW. I have to configure a Wireless controller with 12 AP licences based on the Cisco one model. Please see below the BoM : C1-AIR-CT5508-K9 Cisco ONE - 5500 series WLAN Controller w/ 0 AP lics CON-SNT-CT5508K...
Am I reading the documents correctly that these currently cannot bridge to each other either in Mobility Express mode or connected to a WLC?
Dears,We want to do bandwidth limitation on a specific WLAN on 2500 WLC. what is the steps to do that ?Thanks
Hello, I have a client that is utilizing a pair or 3602 access points configured as autonomous bridges connecting two buildings together. The client is complaining that the performance is very slow across the wireless bridge. Since these access po...
Have not seen any answers to this but must be a question over the years. So I have many access points powered with POE injectors and want to know (and monitor) the power being consumed by the access point to determine if there are problems with the...
Resolved! Source IP of client
So need to validate something: Client --> AP --> WLC --> Switch --> Firewall 10.10.10.10 --> 10.10.10.1 --> 172.10.10.10 Client has an IP 10.10.10.10 AP = 192.168.1.10 WLC = 172.10.10.10 Firewall will see the client IP as the source and NOT the i...
Resolved! Fail Change IP AP
Hello friends.In my network, I have problem to change IP, when I change AP.The network is exclamation point and no more browsing.Has anyone ever had this same problem?
Hello Experts, We recently did a site survey and added more AP's and also changed the position of the existing AP's based on the survey results. We noticed two strange issues. 1>MAC book users located around 10Ft away from the nearest AP has co...
Hello, We have a client that keeps getting dropped right after association is completed. I have run a debug on the client but I am not 100% sure of the issue and wanted to see if anyone has run into this before: (Cisco Controller) >debug client 00:1...
Good morning, we have the following setup on our 5520 controller using ISE 2.2 as the AAA server. As our network engineer left I know nothing about this setup but have been asked to look in to limiting bandwidth on a per user basis, would it be possi...
I'm pretty sure that is the case but wanted to confirm. Even if I configure external authentication on a Cisco WLC I will still need to install a 3r party SSL cert on the WLC to get rid of the error message? There is not way to do it where the requ...
WLC 7500 FLEX - not booting!!! Hi, I have even downloaded the new software (AIR-CT7500-K9-8-0-152-0.aes) and burned it to cd/dvd in ISO and normal format, but it shows the cd/dvd boot failed. Can anyone assist me on this please, or there anyone w...
WLC IOS 8.0.120.0 Hello guys.. I'm about to freak out cuz I can't solve theis issue.. I've read several guides about how to configure the WLC for make it "speak" Bonjour/Airprint. My problem is that I can find those printers I've enabled AirPrint on,...
Hi All We need assistance about the Cisco Vwlc ( virtual wifi controller ) password recovery procedure , we have an already installed Cisco virtual controllr on vmware ESXi , for which we need to do password recovery , if you have any documented pro...
