Wireless

I have 2 different 4400 series controllers running vastly different version of code (7.0.98.0 & 4.1.185.0) that both give me this error when attempting to download the config via TFTP: "TFTP Code File type not supported!"I have successfully downloade...

We are trying to set up a wireless guest network on a WAP4410N.  I know that I have to use a VLANs which I am not the most familiar with.  I have our secure wireless working but the guest one is not getting an IP address.  I am thinking that I need t...

Currently we have a single Cisco 5508 setup for corporate access backed off to ACS and Active Directory.Guest access is using the NAC Guest server with web auth..What the requirements are is for a new SSID and to use the guest interface, so corporate...

Hello ExpertsNeed your inputs / guidance on following requirement.I have two 1142n LWP ap converted into standalone, as client doesn't have any controller there. They just want to extend their network via wireless. L3 switch (trunk port gig 1/48) ---...

olla! is the aironet 1262 access point a good choice for an environment of about 20 users. each users is in an office and we are looking at deploying the ap at the end of the hall on a wall mount. would distance be a barrier and are there any better ...

I have configure 3 SSIDs, two ones are configure to get IP addres from Internat DHCP Server in WLC 2125, buy they are having problems to get the ip addres. I have 6.0.199.4 software release installed. any idea to fix this issue?.

HiAnyone can tell me what is the maximum number of hosts can connect to a single access point.Also is there any option to restrict only specific number of hosts can connect.

How do you move APs from controller to controller without having to restart the APs to avoid downtime?I've tried to manually add the primary controller in the AP config, but the AP doesn't move. I am using a 4404 controller with 1130 APs.

Hi,Did you can help me with this design?I have a 200 users to be connected to the wireless network, these users will connect through its integrated wireless card using 801.11N in their notebook. The dimensions are 50X20 meters or 164x65feet.What is t...

I have three of these AP that quit associating with the controller after a power loss. I have dismounted one of them and it has an Amber light on ethernet LED and Green Light on radio LED and off on status.It does not respond to reset and nothing hap...

I have quite a few wireless networks using a WLCM in 2811 routers. Almost every network has nothing but 1010 WAPs so the WLCMs can't run anything higher than 4.2.209.0. At some sites I've had to replace broken 1010s with 1131s and that's where the pr...

Hello Guys, I was wondering if Cisco recommends to use Intel Proset Wireless software or WZC when using an Intel Wireless adapter to connect to Cisco WLAN's ?Proset is certainly more advanced and has enterprise grade features but what about the perfo...

I need to bridge a printer off a wireless bridge using a 4402 WLAN Controller.  Would I need to make any changes on the 4402 WLAN Controller?

We are using a WLC 2106 running 7.0.116 and notice that when iPhones are streaming data (e.g. YouTube) during WPA re-auths we get the following log entry:Max EAPOL-key M3 retransmissions exceeded for client xxxxxAnd the iPhone prompts for the usernam...

I am trying to connect my AP tp WLC 5500. I checked AP has NO IP. I have NO DHCP server in my network. 1. Do I need IP to be assigned to AP before join the WLC? If Yes I can cosole to AP and set IP but I don't like this method as I have bunch of APs ...