Wireless

Hi,I have 2 WiSM in the branch office and 1 4404 working as Anchor in a DMZ all with the 6.0.188 version. In this moment just 1 AP 1242 is working, in a testing environment with 2 SSID:1. internal WLAN with WPA+WPA2 802.1x with certificates2. Open gu...

I have just converted a WLSE to WCS but the WCS Version is 4.2.62.11I'm looking to upgrade the WCS (Linux) to Ver 6.Can I do this in one step or do I need to go from Ver 4 to Ver 5 and then to Ver 6?Do you still need to uninstall the old WCS version ...

Hi,   I have to upgrade a WCS for a customer to version 6.0.132.0, to support an upgrade of WLC to version 6.0.182.0.Is there an impact on the license when doing an upgrade?Also, i do not know the existing version of WCS installed, but i do know ther...

Dear All, one of my Customers uses 4400 based Guest Access Solution with L3 Webauth. With XP everything works Fine. Since the Migration to Windows 7, Guest Access is not working correctly. It takes a long time to get an IP Address via DHCP, sometimes...

Hi all,is it possible to create a VPN (or other something similar - like GRE) tunnel from any physical/logicel interface of a WLC (running OS 4.2.207.0) to a remote router? We'd like to tunnel the Usertraffic to a remote device to allow the user to a...

Hi all.I've got 2 WiSMs running as my internal controllers and a 5508 as the anchor. the docs I've seen say to have the anchor and the internal controllers in separate mobility groups but the only time i could get them to show 'Up' under control path...

For one of my SSID's I am using 802.1x with WPA2/AES. I have configured IAS on windows server 2003 and from the server message logs I am able to authenticate a user. I never complete the authentication through the eyes of the WLC though. In using deb...

In a WLC (6.0) environment:a) Can I use WPA-PSK (Pre Shared Key)  with CCKM?b) Do i need any extra device?c) Do CCKM requires and external radius?Thanks

I have a client that is looking to fully lock down the 7925 phones.  We have "Disabled" the "Setting Access" which prevents users from changing ring tones and volume, but a few savy users have discovered holding dow the "*" key will put the phone int...

Hi All,Configuring a standalone 1250, and need to configure the management IP.  The management for the switch/access point are not the native VLan.  On a switch I'd just go "int vlan x  ->  ip address x.x.x.x"   But on an AP there is no such option, ...

It's been a while since i've set up 1310s and i'm looking for a good sample config that uses two 1310s as building to building links.  What security to use is a concern.  I also have an ACS server if that will help beef things up.Does anyone have som...

Hi PushkarHi, I have an airespace 4012 and due to a mistake on the update it  caused that the equipment doesn't boot.I didn't take any copy of the firmware, where can i take this old  version from (version 2.0.142.0)? or is it possible to bring it to...

So I have two 3560s with SVIs using HSRP.If I want to spread the 5508 across both switches am I limited to 1 trunk to each switch and I get to watch the other 6 GigE ports on the WLC collect dust since I can't use LAG.  In other words the 5508 can't ...