Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
The 1300 with connectors for external antennas, have it integrate antenna?
Hello friends, I have a problem with a couple of AP 1400 and 1300, which perform point-to-point links between two remote locations. The person who administers these devices is no longer. At the time of accessing the computer does not know the passwor...
Hello,Does anyone know how long the data collection process takes during the calibration process for lbs? I have read in the design guide (4.1) that it can take up to "a few minutes". Is this per data collection point? If so, how far apart are these ...
I fell in the problem described in http://www.cisco.com/en/US/partner/tech/tk827/tk369/technologies_tech_note09186a0080093f1f.shtmlA server sent a MTU greater than 1500 and the frame wasn't able to pass thru a GRE tunnel.I am asking if the same probl...
I tried to use the GUI to upgrade my 1120 and mucked it up. The upgrade wiped out the flash but failed to upload the new .tar file. Now my AP is running (i haven't rebooted it) but I have no GUI. So, I have access to the CLI, I have a tftp server and...
Hello,The volume of wifi users within my organisation is set to increase by approximately 50% in the coming months. We are currently using Cisco Aironet 1200s which are providing a strong /good quality signal for all users. I need to know what is bes...
Hello there,I have following situation.network---wlan controller4402----FW1---MPLS---FW2---Access points----networksI can see very big amount of fragmented packets coming to FW2 and getting dropped in one moment. After those packets get dropped, acce...
HiI have a WLC4404 with the last release, 5.0.148.0, and it suddenly rebootsAnyone has the same situation?Thanks
I've been reading over the "Cisco Wireless LAN Controller Configuration Guide, Release 4.0".So it looks like once you have the HTTPS enabled and the management IP set, the majority of the configuration is through the GUI - clicking your way through a...
Hello, I'm trying to build a stand alone all-wireless network with just an 1131AG access point and 3 clients. This seems to be more difficult than I anticipated. Is there any guidance on how to configure the AP to do this? Thanks in advance.Josh
I have the 1500s installed and have wireless access. The backhaul is not working. I have adjusted tne nortel bps2000 to 100half and still no connectivity. Help!
Hi to all,if i create 2 vlan and i configure 2 ssid one for each vlan, this two vlan are created only for the wireless interface? Or i need to reconfigure all the lan equipment for this 2 vlan?If i configure 2 vlan and the relative ssid i need two bv...
I have an Aironet 1130AG Series Access Point and would like to do the following:When users connect to the access point, a Web page opens asking for a user name and security code. Users can only access the Internet after correctly authenticating.Can t...
I am having a small problem resetting the AP to default config.Off course I have tried the cisco way but the AP still retains some parts of old config. Can someone tell me how to full (clean) reset the AP?Thanks,Piotr,p.s. can option 43 for dhcp help...
Hi dear,Could you please give me some clues how to configure AIR-WLC4402-50-K9 in cluster.Thanks in advanceBest Regards
