Wireless

Hi,I have a colleague who accidentially purchased a number of 1130AG LAP access points. They have since converted them to autonomous and can now configure them.The problem now is that they appear in Cisco Network Assistant as "unknown devices". I am ...

The scenario is the next one: Ten access points and one WLSE Express. One is configured as WDS with a priority of 254, other access point as WDS with a priority of 128, and the other as Infrastructure AP's. The infrastructure AP's are authenticating ...

Has anyone tried the new feature in wcs 5 under configure AP's. You can use a csv file to bulk configure AP's.I'm running wcs 5.0 but my controllers are 4.2.112. Will this feature work, it would allow me to configure the names of more then 100 aps by...

I only found a conversation from 2005 which didn't end with a solution - maybe there is one in the meantime???I made a backup of the old server, put this on the new one, reinitialized the database on the new, made a "successful" restore of the DB - B...

Hi All, We are trying to change the default lease time of 1 day for the guest users created through lobby admin(In wireless LAN controller) .Is there a way to change that default time to some other value. Kindly let me know.Thanks RegardsAnantha Subr...

HiI want to setup a bridge between two sites. The root bridge which is installed at the first site cannot cover the second site's area. For this reason I want to use a repeater between these sites to increase the signal's strength.I have 3 aironet 12...

We have recently started implementing 1242AG APs onto our system. We are using WCS 4.2.62.0 with 1242 LWAPP APs. We keep getting both 802.11a and 802.11 b/g listings on our controller. Is there a way to get rid of the 802.11a listing on our controlle...

I have wireless lan controller 2xxx and created a separate guest wlan and vlan and need to give them only internet access. If I have a PIX, should I put them in the PIX dmz and just have a switchport in guest vlan connected to PIX DMZ port?Or is ther...

Hello, I have a WLC in my central office working well wich several access point 1231 lwapp. I need install new access point 1231 lwapp in my branch office that is concted to my central office via WAN link (MPLS)and do not have a WLC local. I know tha...

Is there any way to have an AP1232 acting as a bridge, configured to use NAT and distribute a private IP address range to clients, instead of doing a "pass through" to be assigned a DHCP address from the MS DHCP server?Thanks.

I have 2 WLC 4404 with capacity of 100 AP each one and i have 170 AP around the country (MX).all 170 ap's in this moment work in autonomous mode, i want to upgrade each one to LAP mode, i starting with 2 in one location trough the WAN but after i upg...

I have 3 AIR-LAP1242AG-A-K9 connected to a Cisco 4006 and the FCS,Xmit, and Rcv errors are quickly incrementing. The switch ports are set @ "auto/auto" for speed/duplex.The WLC is running version 4.0.217.0, and I can't find a way to check/change the ...

Hello,Ciscoworks is often reporting the event HighQueueDropRate on some ofmy wireless routers (837, 877w, ...)for example, today : InputPacketQueueDropPct 1.6998109 %but it could be OutputPacketQueueDropPct.basically, the value is set to 1% (default ...