Wireless

Hello,I have used the command snmpset to change the properties of my ap.After that, i got the following message:Notification: Interface Dot11Radio0, changed state to reset.When the AP resets its state, all the clients are disconnected. How can i avoi...

Can a controller reach a radius server through the service port?

Hi,I'm looking to deploy a WLAN network using AP's, Radius and Certificates.Do I need a WLAN controller? If so, what does it perform.SD

I would like to know what is the difference between the Wireless Lan Controller and the Wireless Controller System.Need I WLC if I want deploy WCS.Can I use WCS without Wireless LAN Controllers?.Thanks

I have a 4400 configured with a private wlan and a number of 1100 APs on 3 subnets. The APs get the correct IP but clients connected get an IP from the same subnet as the controller.i.e.subnet 1 10.1.1.1-254 (4400 + 4 APs - APs & clients get 10.1.1.x...

I have to WLAN one is in the same subnet as the managment and ap-manager which works fine. All the AP's are in the same subnet as the managment interface. I have create a second interface on a different subnet and have the second WLAN mapped to it.Al...

So has anyone yet jumped up to this release? I'm on 4.1.190.5 and wondering if the improvements are worth the outage it causes.I am hoping thay they have Secondary Backhaul working anywhere near how it should yet.

Guys,anyone know how to get a AP back online if it continues to flash?i've tried to reboot the AP - but no luck!!thanks..

Hello,I am looking for a solution where by I can provide wireless converage (wireless carpeting) over 3 kms. The situation is as below:1) I have a huge consturction site. (3kms or more and its a desert). I want to provide wireless network from a base...

when AP names are updated on a WLC, how to propagate the changes to the WCS? WCS still shows the AP names as MAC addresses instead of user-friendly names that were set on the WLC.

I am usint the site survey option o nthe 7921g phone. It will display the channel, bssid, rssi, and CU. I am trying to track the BSSID to a particular access point. I thought it was a part of the mac address but it is not. The mac address of the acce...

Hello all - I've searched throughout the Wireless forums regarding a very common setup but with an exception - guest acccess. I may be missing something here but hopefully someone can assist me in this matter.What I am looking to do is setup a wirele...

I have a customer (Hotel) that has multiple conference rooms throught it's buildings. These conference rooms are around and below guest suites. They would like a good strong wireless signal inside each of the guest suites but would like to keep the w...

Hi guru's, I asked cisco for a WCS demo license and i received it via mail, but my WCS 4.1.91 does not accept the license. I get the message;invalid license file, unknown feature type 'SPECTRUM_EXPERT' detectedThe hostname is correct, and the second ...

Hi All,I am trying to get a LAP at my remote office to register back to my WLC at HQ,Remote office is currently using tunnel VPN IPSEC over TCP.Is that possible?I tried this setup, but failed to work. Debug dhcp and debug lwapp on the WLC shows nothi...